4948Volume lightSpeaker Volume Control1 Open “MENU”With the DVD in stop mode, press the MENU button.2 Select “Install”Using the up/down and left/right buttons, move the selection cursorto “Installation”, then press ENTER to select.3 Select “Volume light”Move the selection arrow to “Volume light”, then press right toselect from the following options.• Auto - Volume light (light surrounding main unit volume control)will be turned off automatically.• On - Volume light will be bright all the time.1 AMP Volume Control• Connect the speakers to the speaker jack on the rear.• When you turn the power ON, if the last volume level was over20, the volume will be set to 20, and if it was under 20, thevolume will be set to that level.2 Headphone Volume Control• You can adjust the volume by connecting the headphone to theHeadphone JACK on the front panel.• The speakers will be muted.• The LINE OUT AUDIO will be output continuously while theHeadphone is connected.MAIN MENUInstallationRETURN ❷ ENTERProgram Clock Install ExitDVD VCR Options LanguageInstallINSTALLATIONChannel setup❿ Volume light : [Auto]RETURN ❷➛❿AutoOnConnect the front, center, and surround speakers and thesubwoofer to the speaker terminals on the back of the main unit.1 Connect the speakers to the speaker output terminals on the backof the main unit, matching the colors.CautionDo not set the Speakers (except center speaker) near the TV or Monitorbecause they are not magnetic shielded.Connecting the SpeakersRADIO ANT.DVD OlnyCOMPONENT VIDEO OUTSPEAKERSAMFM75COAXALS-VIDEO OUTCENTER SURROUND L FRONT LWOOFER SURROUND R FRONT RIN(FROM ANT.)OUT(TO TV)RFVIDEOAUDIODVD & VCRLINEIN 1LINEIN 2LINEOUTRLSPEAKERSCENTER SURROUND L FRONT LWOOFER SURROUND R FRONT RCenter SpeakerCenter SpeakerFront Speaker (R)Front Speaker (L)SubwooferSubwooferSurroundSpeaker (L)SurroundSpeaker (R)SurroundSpeaker (L)SurroundSpeaker (R)FrontSpeaker (L)Front Speaker (R)