5ENInstalling the HobImportant: Be sure the new appliance is installed and grounded only by qualifiedpersonnelPlease observe this instruction The warranty will not cover any damage that mayoccur as a result of improper installationTechnical data is provided at the end of this manualRegulations and complianceThis appliance meets the following standards:• EN 60 335 - 1 and EN 60 335 - 2 - 6, relating to the safety of electrical appliances forhousehold use and similar purposes;• EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electriccookers, hobs, ovens, and grills for household use;• EN 55014 - 2;• EN 55014;• EN 61000 - 3 - 2; and• EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC)This appliance complies with the following EU Directives:• 73 / 23 / EWG dated 19 02 1973 (Low Voltage Directive);• 89 / 336 / EWG dated 03 05 1989 (EMC Directive including Amending Directive92 / 31 / EWG); and• 93 / 68 / EWG CE Labeling DirectiveSafety instructions for the installer• With respect to fire protection, this appliance corresponds to EN 60 335 - 2 - 6. This type ofappliance may be installed with a high cupboard or wall on one side• Drawers may not be fitted underneath the hob.• The installation must guarantee shock protection• The kitchen unit in which the appliance is fitted must satisfy the stability requirements ofDIN 68930• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant• On tiled work surfaces, the joints in the area where the hob sits must be completely filledwith grout• On natural, artificial stone, or ceramic tops, the snap action springs must be bonded inplace with a suitable artificial resin or mixed adhesive.• Ensure that the seal is correctly seated against the work surface without any gapsAdditional silicon sealant must not be applied; this would make removal more difficult whenservicing• The hob must be pressed out from below when removedC21RJAN_BOL-00139A-02_EN.indd 5 23/11/2555 17:22:59