2_ connectionsconnectionsCOnnECTing TO a TV (ViDEO) - gOOD QUaLiTYUsing video/audio cables, connect the ViDEO (yellow) / aUDiO (red and white) OUT terminals on the rear ofthe Blu-ray Disc Player to the ViDEO (yellow) / aUDiO (red and white) in terminals of your TV.Turn on the Blu-ray Disc Player and TV.Press the input selector on your TV remote control until the Video signal from the Blu-ray Disc Player appearson the TV screen.If you have set the remote control to operate your TV (see pages 20~21), press the TV SOUrCE button onthe remote control and select VIDEO as the external source of the TV.Noise may be generated if the audio cable is placed too close to the power cable.If you want to connect to an Amplifier, please refer to the Amplifier connection pages. (See pages 27~30)The number and position of terminals may vary depending on your TV set. Please refer to the user's manualof your TV.If there is only one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of theBlu-ray Disc Player.The VIDEO source is always output in 480i resolution regardless of the resolution set in the SETUP menu.(See page 45)1.2.3.•M WhiteRed YellowAudio/Video cable
