Samsung 018 Series User & Installation Manual

50Setting indoor unit installation optionsSetting an indoor unit installation option (suitable for the condition of each installation location)1. Make sure power is ON to the outdoor unit.2. The panel display should be connected to the indoor unit to receive option settings.3. Set the installation option according to the installation requirements of the air conditioner.Xf The default indoor unit installation option setting is “020000-100000-200000-300000”.Xf Wireless remote controller address (SEG20) allows control of an indoor unit individually when there is more thanone indoor unit in a space. This prevents unwanted overlapping of cotroller signal to different units.Xf No need to assign SEG3, 6, 8, 9, 10, 11, 16, 21, 22, 23, 24 which are non applicable. Even if these segments are set,they will be ignored.Xf If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.4. Set the indoor unit option by wireless or wired remote controller.Option No. : 02XXXX-1XXXXX-2XXXXX-3XXXXXOption SEG1 SEG2 SEG3 SEG4 SEG5 SEG6Explanation PAGE MODERESERVEDUse of externaltemperature sensor Use of central control RPM settingcompensationSetting/DetailsIndication Details Indication Details Indication Details Indication Details 0. Not used1. High ceiling mode2. High ceiling kit0 2 0 Disuse 0 Disuse1 Use 1 UseOption SEG7 SEG8 SEG9 SEG10 SEG11 SEG12Explanation PAGE Use of drain pump*RESERVED RESERVED RESERVED RESERVEDSetting/DetailsIndication Details Indication Details10 Disuse1 Use2Use +3minutedelayOption SEG13 SEG14 SEG15 SEG16 SEG17 SEG18Explanation PAGE Use of external control Setting the output ofexternal control S-Plasma ion Buzzer control Number of hoursusing filterSetting/DetailsIndication Details Indication Details Indication Details Indication Details Indication Details Indication Details20 Disuse 0 Thermo on 0 Disuse 0 Use ofbuzzer 2 1000 Hour1 ON/OFFControl 1 Operationon 1 Use 1 Non use ofbuzzer 6 2000 Hour2 OFF Control