Revised A 64 63016. Assembly and disassembly (continued)6.8. Fittings and hoses6.8.1. Fittings removalRemove fittings and hoses from the atomizer robot adaptor• Step 1: Use one tool P/N 1305453 and to hold the hose• Step 2: Place the second tool P/N 1305453 and turn counterclock wise to remove.• Step 3: Install new hoses on fittings6.8.2. AssemblyNote: Make sure to shorten hose by 0.6 Inch (15 mm) if previously used.• Step 1: Fit hose in the tool P/N 1406390 mark as shown• Step 2: Place tool and fitting onto hose and turn clockwise to tighten until it reaches the markWARNING : Do not apply too much force while tightening. If hose turns, cut again and re-installthe fitting. For correct tube fittings and o-rings see § 8.7 page 81.• Step 3: Reconnect the fitting and hose on the quick disconnect robot plateDES01090DES01091Mark the tubing with apermanent markerDES01090
