Revised A 41 63015. Maintenance (continued)5.3.4 Low voltage cable wiring instructions (continued)Step 10:Secure the electrical connector assembly with the (4) plastic screws.Step 11:Feed cable ends through the 5/16” nylon tubing.Step 12:Place the nylon tubing inside the connector and secure with connector and 2 S/S screws.5.3.5. UHT 153 CascadeNote:• After installing the UHT 153 into the quick disconnect, apply a light film of dielectric grease to therod and high voltage contact before installing the PPH 607 manifold.• Be sure to tighten the cascade set screw to prevent the cascade from falling out and breaking.High voltagecontactZero degree indexing positionCascade set screw
