Regency Fireplace Products I31-NG3 Owners And Installation Manual

Regency Fireplace Products I31-NG3 Owners And Installation Manual Manual pdf 8 page image

8 Regency I31-3 Gas Fireplace InbuiltLOG SETINSTALLATIONRead the instructions below carefully and re-fer to the diagrams. If logs are broken do notuse the unit until they are replaced. Brokenlogs can interfere with the pilot operation.The gas log kit contains the following:a) 02-43 Rear Log 902-227b) 02-45 Front Right Log 902-229c) 02-56 Middle Left Log 902-230d) 02-46 Left Top Log 902-231e) 02-47 Center Log 902-232f) 02-48 Middle Right Log 902-226g) 02-44 Front Left Log 902-228h) Embers and Rockwooli) Vermiculite and Ember combinationNote: Install Optional Brick Panels prior toinstalling logs.Vermiculite andembers. Vermiculite andembers.Vermiculite andembers.The "02" refer numbers (i.e. 02-43) aremolded into the rear of each log.INSTALLATIONThe smoke should be drawn into the spill tube.If the smoke is still not drawn into the spill tube,turn the unit off and check for the cause of thelack of draft. If necessary, rectify.Diagram 1Diagram 2Diagram 3For wind turbulent sites, a wind cap may remedythe problem.Note: The thermally activated safety switchwill sense the change in temperature and shutdown the gas valve in the event of a severedowndraft or a blocked or disconnectedfl ue. The switch acts as a safety shut-off toprevent a build-up of carbon monoxide. If thefl ue is blocked or has no "draw", the switchwill automatically shut off the supply of gaswithin 5 - 10 minutes. Tampering with theswitch can result in carbon monoxide (CO)poisoning and possible death.If the heater turns off because of lack of draftduring the spillage test, check for the causeand if necessary, rectify.The thermally actuated safety switch willautomatically reset after it has cooled off.The switch will continue to cycle until thedraft problem is corrected. DO NOT BYPASSOR DISCONNECT THIS SWITCH.OPTIONALBRICK PANEL1) Unwrap the brick pattern panels from theprotective wrapping.2) Remove the glass front if it is already installed(see manual).3) Put the rear brick panel flat against the backof the unit.4) Before installing the side brick panels, loosenthe screws for the brick tabs enough so thatyou can slide the brick tabs on to the screwseasily but that the tabs are secure. For thelocation of the side brick tab screws seediagram 1.5) Remove the brick tabs and slide the sidebrick panels into position. See diagram 3.Install the brick tabs. See diagram 2.1) Carefully remove the logs from the box andunwrap them. The logs are fragile, handlewith care - do not force into position.2) Sprinkle the vermiculite and ember combina-tion around the firebox base.3) Place Rear Log A)02-43 on the two pins onthe rear log support.