Regency Fireplace Products I31-NG3 Owners And Installation Manual

Regency Fireplace Products I31-NG3 Owners And Installation Manual Manual pdf 10 page image

10 Regency I31-3 Gas Fireplace InbuiltFLUSH FRONTINSTALLATION1) Install Logs before going on to the next step.See the Log Installation instruction sheet orpage 8 in the manual.2) Install the bottom glass trim by hooking thetrim into the lip on the firebox base. The trimwill not fit into place if the glass is installedfirst.Diagram 1Diagram 3Diagram 4FACEPLATE & TRIMINSTALLATION1) Lay the faceplate panels flat, face down onsomething soft so they don't scratch.2) Take the top faceplate and align the holesin it with the holes in the side panels. Us-ing the screws provided, attach from thetop of the panel (the holes in the top panelare slightly larger than the holes in the sidepanel to facilitate easier installation). Seediagram 1.Diagram 2Rear View: Trim AssemblyDiagram 5Hint: Don't tighten the trim to the bottomof the faceplate side panels with the screwsprovided. See diagram 1.3) Using the connectors provided, join the leftside trim (with the ON/OFF switch) to thetop trim. Connect the right side trim to thetop trim.See diagram 2.4) Place the trim on the assembled faceplatepanels, aligning the wire connections fromthe switches with the notch on the left sidepanel.5) Hookup the 3 Fan Switch wires to the fanswitch on the left side trim. Diagram 3.WARNING: The 3 wires are to theFan and the 2 wires are to the ON/OFF burner switch. DO NOT con-nect to the wrong switch.WARNING:Ensure that the wires do NOTtouch the fireboxINSTALLATION6) Connect the 2 burner ON/OFF switch wiresby taking the yellow and orange wires withthe female ends and connecting them tothe burner ON/OFF switch.7) Tuck the wires into the faceplate to keepthem away from the inbuilt fireplace usingthe clip provided. Attach the clip to the rearof the faceplate to ensure that the wires donot touch the side of the unit. See diagram3.8) The power cord should be run behind thefaceplate panel.9) Attach the brass trim to the faceplate bydrilling a 1/8" hole through into the faceplateusing the hole in the trim as a guide. Fastenthe trim to the faceplate panels using theplated screws. See diagram 4.10) Attach the faceplate panels* to the inbuiltfireplace body using the 4 remaining blackscrews. See diagram 5.11) Push the Regency logo plate into the twoholes in the bottom left corner of the face-plate. See diagram 4.