QNAP HS-210 Hardware User Manual

Also see for TS-863U: Hardware user manual Hardware user manual Hardware user manual User manual

Contents

QNAP HS-210 Hardware User Manual Manual pdf 35 page image

35Chapter 2. Power Button and Reset Button Behavior Power button: Press to turn on or turn off.System Power button(Turn on)Power button(Hardware turnoff)Power button(Force turn off)All models Press once 1.5 sec 5 sec Reset button: Press to reset the system settings.System Basic system reset(1 beep)Advanced system reset(2 beeps)All models 3 sec 10 secBasic system reset (3 sec)Press the reset button for 3 seconds, a beep sound will be heard. The following settings arereset to default: System administration password: admin TCP/IP configuration: Obtain IP address settings automatically via DHCP TCP/IP configuration: Disable Jumbo Frame TCP/IP configuration: If port trunking is enabled (dual LAN models only), the porttrunking mode will be reset to “Active Backup (Failover)”. System Port: 8080 (system service port) Security Level: Low (Allow all connections) LCD panel password: (blank)* VLAN will be disabled*This feature is only provided by the NAS models with LCD panels. Please visithttp://www.qnap.comfor details.Advanced system reset (10 sec)Press the reset button for 10 seconds; you will hear two beeps at the third and the tenthseconds. The NAS will reset all the system settings to default as it does by web-basedsystem reset in “Administration” > “Restore to Factory Default” except all the data arereserved. The settings such as the users, user groups, and the network share folderspreviously created will be cleared. To retrieve the old data after the advanced system reset,create the same network share folders on the NAS and the data will be accessible again.