Pioneer ddj-t1 Operating Instructions Manual

Also see for DDJ-T1: Operating instructions Service manual Operating instruction Operating instructions Service manual

5EnEnglishAbout the AC adapterSafety instructionsTo ensure your personal safety and to maximize the full operating poten-tial of your unit, read and follow these safety instructions.Read & Retain InstructionsRead all operating and user information provided with this product.CleaningUse a damp cloth to clean the exterior housing. Avoid using any fluidsincluding liquid, aerosol or alcohol-based cleaning products.Water or MoistureAvoid operating or locating this product near water or other sources offluid.AccessoriesDo not place this product on an unstable cart, stand, or table. The prod-uct may fall and be seriously damaged.VentilationDo not block or cover this product in use. This unit should not be placedin a built-in installation unless properly ventilated.EnvironmentAvoid placing this product in a location with exposure to large quantitiesof dust, high temperatures, high humidity, or subject to excessive vibra-tions or shocks.Power SourcesOperate this product only from the recommended power sources. Ifyou are unsure of the power source, consult an authorized Pioneerrepresentative.Power-Cord ProtectionWhen unplugging the unit, pull on the plug – not on the cord. Do nothandle the cord or plug with wet hands; doing so could cause an electricshort or shock. Do not allow anything to pinch or rest on the power cordand do not place in a walkway.PowerTurn OFF the system before installing this or any other hardware device.OverloadingAvoid connecting too many devices to a single wall socket or powersource as this can cause fires or short circuits.Object & Liquid EntryNever push inappropriate objects in to the device. Avoid spilling anyliquids in to or on the outside of the drive.ServicingOpening or removing the cover exposes you to possible electrical shockor other danger. Contact a Pioneer authorized service representative forrepairing this product (refer to the enclosed Service & Support Card).Damage Requiring ServiceUnplug the unit and refer servicing to qualified service personnel in thefollowing situations:! When the power cord, plug, or chassis is damaged.! If liquid has been spilled, or objects have fallen into the product.! If the product has been exposed to rain or water.! If the product does not operate normally when the operating instruc-tions are followed. Adjust only those controls that are covered by theoperating instructions. Improper adjustment of other controls mayresult in damage and can require extensive work by a qualified tech-nician to restore the unit to its normal operation.! When the product exhibits a distinct change in performance – thisindicates a need for service.Check that there are no irregularities with the AC adapter or power plug,then insert the power plug into the specified position of the AC adapterusing the specified procedure until a click is heard. For details, seeMounting the power plug on page 5.If there are irregularities with the AC adapter or power plug, ask yournearest Pioneer authorized service center or your dealer to carry outrepair work.! Do not use this unit with a coin, paper clip or other metal objectstuck between the AC adapter and power plug. Doing so could causea short circuit, leading to fire or electric shock.! When mounting the AC adapter on a wall outlet, make sure there isno space between the AC adapter and the wall outlet. Faulty contactor a coin, paper clip or other metal object getting stuck in the spacecould cause a short circuit, leading to fire or electric shock.Side TopCoin, paper clip or other metal object! The power plug could come detached from the AC adapter andremain in the power outlet if someone trips on the AC adapter’spower cord or if something hits the AC adapter. If this happens,remove the power plug remaining in the outlet with dry hands, hold-ing it as shown on the diagram below and without touching metalparts. Do not use any tools to remove it.Do not touch metal parts.Mounting the power plugSlide the power plug along the guide rails in the ACadapter unit as shown on the diagram below, then pressin until a click is heard.PUSHPUSH