Pioneer XW-NAS5 Operating Instructions Manual

Also see for XW-NAS5: Operating instructions

Contents

Additional information0924EnResetting the systemUse this procedure to reset all system settingsto the factory default.• When performing reset, first disconnect allcomponents connected to this unit.1 Switch the unit on.2 Press and hold VOLUME – on the toppanel, and then press and hold  STANDBY/ON for three seconds.Power is set to standby mode.The next time you switch on, all the systemsettings should be reset.About iPod/iPhone“Made for iPod” and “Made for iPhone” meanthat an electronic accessory has beendesigned to connect specifically to iPod oriPhone, respectively, and has been certified bythe developer to meet Apple performancestandards. Apple is not responsible for theoperation of this device or its compliance withsafety and regulatory standards.iPod and iPhone are trademarks of Apple Inc.,registered in the U.S. and other countries.The Bluetooth wirelesstechnology device cannot beconnected or operated. Soundfrom the Bluetooth wirelesstechnology device is notemitted or the sound isinterrupted.• Check that no object that emits electromagnetic waves in the 2.4GHz band (microwave oven, wireless LAN device or Bluetoothwireless technology apparatus) is near the unit. If such an object isnear the unit, set the unit far from it. Or, stop using the objectemitting the electromagnetic waves.• Check that the Bluetooth wireless technology device is not too farfrom the unit and that obstructions are not set between the Bluetoothwireless technology device and the unit. Set the Bluetooth wirelesstechnology device and the unit so that the distance between them isless than about 10 m (32 ft.) and no obstructions exist between them.• Check that the Bluetooth ADAPTER and the ADAPTER PORT of theunit are correctly connected.• The Bluetooth wireless technology device may not be set to thecommunication mode supporting the Bluetooth wireless technology.Check the setting of the Bluetooth wireless technology device.• Check that pairing is correct. The pairing setting was deleted fromthis unit or the Bluetooth wireless technology device. Reset the pairing.• Check that the profile is correct. Use a Bluetooth wirelesstechnology device that supports A2DP profile and AVRCP profile.Problem Remedy