Pioneer S-LX70C Operating Instructions Manual

Also see for AS-LX70: Operating instructions Operating instructions Operating instructions Service manual Service manual

Contents

The Initial Setup menu15154EnAnalog TunerAuto Channel Setting Auto Scan Select your country and then wait for the recorder to auto tune into channelsin your area. After auto scan has finished, the channel mapping screenappears showing which channels have been assigned to which programmenumbers. You can skip unwanted channels using the Manual CH Settingoption below.Press HOME MENU to exit the channel mapping screen.Download from TV If your TV supports this feature you can download all the channels that yourTV is tuned to via the SCART input. Select your country and then wait for thedownload to complete. After the download is complete, the channelmapping screen appears, as above.See also the operating instructions that came with your TV for moreinformation.Manual CH Setting Next Screen Proceed to the next screen if you need to adjust any of the settings made byauto tuning. Select your country, then proceed to the manual channelsetting screen:• Change channel presets using the CH +/– buttons (LCD page 2).• To skip the displayed channel (because there is no station assigned to thatchannel), change the Skip setting to On.• Set the CH SYSTEM setting to match the channel system of your countryor region.• Set the CHANNEL setting to the channel you want to assign to the currentchannel preset.• To manually fine tune the channel, change the AFT setting to Off thenadjust the Level setting.• Set the Sound System setting to match the sound system of your region.• The Name field allows you to input a name of up to five characters for thecurrent channel preset.• If the currently selected channel is scrambled requiring a decoderconnected to the AV2 (INPUT 1/DECODER), set the Decoder setting to On.Channel Swapping Next Screen Proceed to the next screen to swap channel assignments of different presetsso that you can group together presets that naturally go together. Select twopresets to swap then press ENTER.Video In/OutInput Colour System Next Screen Proceed to the next screen to set the input colour system for the externalinput and the built-in TV tuner. Use the CH +/– or INPUT buttons (LCD page2) to change the preset or external input. On the default Auto setting therecorder can generally correctly detect whether the input signal is PAL,SECAM, 3.58 NTSC or PAL-60, but in some cases you may have to set itmanually if the picture is displayed incorrectly.• Input Colour System cannot be set when the recorder is in D.TV mode.• See also About the input colour system on page 161 for more information on this setting.AV1 Out Video • Sets the AV1 (RGB)-TV SCART output to standard composite video(compatible with all TVs).S-Video Sets the AV1 (RGB)-TV SCART output to S-Video. Recommended if you areusing a long SCART cable.RGB Sets the AV1 (RGB)-TV SCART output to RGB. Good quality but check yourTV for compatibility. Note that on this setting signals from the built-in tunerand from external input is not output when the recorder is in TV mode.If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnectusing the supplied video cable, or reset the recorder (see Resetting the recorder on page 175).Setting Options Explanation