Turning the unit on% Press SOURCE to turn the unit on.When you select a source, the unit is turnedon.Selecting a sourceYou can select a source you want to listen to.To switch to the built-in CD player, load a discin the unit (refer to page 22).% Press SOURCE to select a source.Press SOURCE repeatedly to switch betweenthe following sources:TunerTelevisionDVD player/Multi-DVD playerBuilt-in CD playerMulti-CD playerExternalunit 1 Externalunit2AUXNotes! In the following cases, the sound source willnot change: When there is no unit corresponding to theselected source connected to this unit. When there is no disc in the unit. When there is no disc in the DVD player. When there is no magazine in the multi-CD player. When there is no magazine in the multi-DVD player. When the AUX (auxiliary input) is set to off(refer to page 46).! External unit refers to a Pioneer product (suchas one available in the future) that, althoughincompatible as a source, enables control ofbasic functions by this unit. Two external unitscan be controlled by this unit. When two exter-nal units are connected, the allocation ofthem to external unit 1 or external unit 2 isautomatically set by this unit.! When this units blue/white lead is connectedto the vehicles auto-antenna relay controlterminal, the vehicles antenna extends whenthis units source is turned on. To retract theantenna, turn the source off.Loading a disc1 Press OPEN to open the front panel.CD loading slot appears.# After a CD has been inserted, press SOURCEto select the built-in CD player.2 Insert a CD into the CD loading slot.Playback will automatically start.CD loading slotEJECT button# You can eject a CD by pressing EJECT.# To avoid a malfunction, make sure that nometal object comes into contact with the term-inals when the front panel is open.Notes! The built-in CD player plays one standard, 12-cm or 8-cm CD at a time. Do not use an adap-ter when playing 8-cm CDs.! Do not insert anything other than a CD intothe CD loading slot.! There is sometimes a delay between startingup CD playback and the sound being issued.When being read, Format Read is displayed.! If you cannot insert a disc completely or ifafter you insert a disc the disc does not play,check that the label side of the disc is up.Press EJECT to eject the disc, and check thedisc for damage before inserting it again.Basic OperationsEn 11EnglishSection03