Pioneer CDJ-850 Operating Instructions Manual

Also see for CDJ-850: Operating instructions Service manual Operating instructions Quick start guide Owner's manual

En 17OperationsOperationsSetting the source to be playedPCUSBDISCVINYLSPEED ADJUSTDISC EJECTSTANDBYBACKBROWSE TAG LIST INFO MENUUTILITY21USBSTOP1 / 81 /16/REMOVETAG TRACKTIMEMODEAUTOCUErbcde f i j k l n o pCJImLoading discs! Set the disc with the printed side facing up.! Insert the disc horizontally into the disc insertion slot in the mainunit’s front panel.! Do not load more than 1 disc.! Do not force discs into the set’s disc insertion slot when the set’spower is off. Doing so could damage the disc or the set.! When the disc is being drawn in or ejected, do not apply any forceto the disc in the direction opposite its movement. Doing so coulddamage the disc or the set.1 Press [u] C.Turn on the power of this unit.2 Load the disc in the disc insertion slot I.Playback starts.! When auto cue is turned on, playback starts when[PLAY/PAUSEf] is pressed. For details on the auto cue function,see Setting auto cue on page 21.Ejecting discsPress [h DISC EJECT] r.The disc is ejected from the disc insertion slot.! If [DISC EJECT h] is pressed accidentally, press [PLAY/PAUSEf]immediately to return to the status directly before [DISC EJECT h]was pressed. (No sound is output during this time.)About ejecting discs by force! If the disc is not ejected when [DISC EJECT h] is pressed, the disccan be ejected forcibly by inserting the disc force eject pin into thedisc force eject pin insertion hole on the main unit’s front panel.! When forcibly ejecting a disc, be sure to do so following the proce-dure below.1 Press [u] C to turn this unit’s power off, then wait atleast 1 minute.Never forcibly eject a disc directly after turning off the set’s power.Doing so is dangerous for the reasons described below.! The disc will still be spinning when ejected and could hit yourfingers, etc., causing injury.! Also, the disc clamp will rotate in an unstable way, and the disccould get scratched.2 Use the included disc force eject pin. (Do not useanything else.)The included disc force eject pin is mounted on the CDJ-850’s bottompanel. When the pin is inserted all the way into the insertion hole, thedisc is ejected 5 mm to 10 mm out of the disc insertion slot. Grasp thedisc with your fingers and pull it out.Loading USB devicesConnect the USB device to the USB device insertion slot d.The USB indicator lights.Removing USB devices from the set! Be sure to follow the procedure below when removing USBdevices from the set. Removing a USB device without followingthis procedure could erase the set’s management data and make itimpossible to read the USB device.! When turning the set’s power off, be sure to remove the USB devicefirst.1 Press [USB STOP] b for at least 2 seconds.The USB indicator turns off.2 Disconnect the USB device.Using the [BROWSE] buttonWhen [BROWSE] is pressed, the contents of the medium loaded in thisunit are displayed on the information display section.Browsing libraries and foldersThis displays the loaded tracks, sorted in category or tree structure.The display on the information display section differs according towhether or not library information is recorded on the USB device.— With library information d Library browsing: The music files aredisplayed by the categories set in rekordbox (album, artist, etc.).The category types can be changed in the Preferences (environ-mental settings) in rekordbox.— Without library information d Folder browsing: The folders/trackson the medium are displayed with a tree structure.Contents recorded on discs cannot be viewed in the library browsemode.Title 01Title 02Title 0321