OneStart

Menu
Pioneer Brite Striper 2000 Instruction Manual & Parts List Manual pdf 7 page image

Pioneer Brite Striper 2000 Instruction Manual & Parts List

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 preview
Contents
  1. Table Of Contents
  2. Handle Assembly
  3. Speed Control Cable
  4. Adjustable Spray Box
  5. Before Starting
  6. Care and Operation of Paint Tank Unit
  7. Operation of Machine
  8. parts list
  9. Striping Tips
  10. Clean-Up Tips
  11. trouble shooting
  12. Customer Service
  13. limited warranty
Pioneer Brite Striper 2000 Instruction Manual & Parts List Manual pdf 7 page image
4 MODEL 2000BEFORE STARTINGThe 2000 STRIPER is shipped with engine oil. Be sure to check the en-closed Operating and Maintenance instructions for proper oil. Follow fill-ing directions.1.Carefully read and follow instructions for starting and maintainingthe engine (in a separate booklet furnished with your machine).2.Check all hose connections and fittings making sure they are tight.3.Be sure paint tank pump assembly is sealed tightly. Refer to careand operation of tank unit section.4.Check to make certain that paint tank is secured tightly.5.Any fittings, if replaced, should have teflon tape applied beforetightening. Do not force fittings on paint tank bushings. Alwayshold nut on paint tank bushing when tightening fittings.DO NOT TIGHTEN FITTINGS WITH PRESSURE IN TANK.CARE AND OPERATION OF COMPRESSORThe piston-type compressor requires minimal maintenance.Pre-lubricated ball bearings for delivery of oil free air.APPLYING OIL TO ANY PART CAN RESULT IN REDUCED PERFORMANCEAND MAY VOID WARRANTY.The compressor is designed to release pressure at approximately40 to 45 PSI. If it is not releasing, contact us immediately. You mayhave a defective or damaged relief valve. If striper is left idling the releasevalve on tank will release pressure.The air filter (part# 1632) should be replaced whenever it becomes dirtyand/or clogged.Operate compressor at lowest engine speed practical.
/ 20
This manual is suitable for:
Brite Striper 2000
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved