OneStart

Menu
Pioneer Brite Striper 2000 Instruction Manual & Parts List Manual pdf 14 page image

Pioneer Brite Striper 2000 Instruction Manual & Parts List

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 preview
Contents
  1. Table Of Contents
  2. Handle Assembly
  3. Speed Control Cable
  4. Adjustable Spray Box
  5. Before Starting
  6. Care and Operation of Paint Tank Unit
  7. Operation of Machine
  8. parts list
  9. Striping Tips
  10. Clean-Up Tips
  11. trouble shooting
  12. Customer Service
  13. limited warranty
Pioneer Brite Striper 2000 Instruction Manual & Parts List Manual pdf 14 page image
11REV 2/08CLEAN UP TIPSAll parts of your PIONEER Brite Striper ® 2000 should be cleaned immediatelyafter each use. We recommend Pioneer P.H.D. Cleaner. A clean, lint-free ragshould be used to wipe dry the inside of the tank.A final step should then be to remove the nozzle caps and clean the nozzle tipsand screens. This can easily be done by placing all three parts into a small can ofsoapy water and allowing them to soak for a few minutes. An old toothbrush canbe used for stubborn spots. Rinse Nozzle Assembly parts with clean water andallow to air dry. Do not store with pump locked in tank, leave loose.CAUTION: DO NOT USE WIRE OR ANY OTHER OBJECT TO CLEAN NOZZLE TIP ASTHIS MAY CAUSE TIP ORIFICE TO BECOME ENLARGED WHICH WILL RESULT INPOOR PERFORMANCE WHEN STRIPING.HOW TO STORECleaning your machine thoroughly cannot be overemphasized. A littleextra effort at the end of each job will save you time and money whenit is time to stripe again. As stated previously, run a tankful of waterthrough the machine. Be sure to clean out screen inside the Nozzle As-sembly.IMPORTANT: BE SURE TO CLEAN PUMP UNIT IN TANK. IMMERSE IN CLEANING SO-LUTION AND PUMP SEVERAL TIMES. FAILURE TO DO THIS MAY RESULT IN LEAKSOR MALFUNCTION IN THE UNIT.When storing your striper for an extended period, do the following:1. Flush machine out thoroughly.2. Remove hoses and drain.3. Run engine until gas tank is empty.4. Wipe the sides and bottom of the inside of the tankwith a clean dry rag.5. Lubricate spray valve (shut-off valve).6. Apply vaseline or similar substance to pump gasket.7. Do not store with pump assembly tight.NORMAL WEARWarranty will not cover repair where normal use has exhausted thelife of the part. Line stripers, like all mechanical devices, need periodicparts replacement and service to perform well. It should be rememberedthat the service life of any equipment is dependent on the care itreceives and the conditions under which it has to operate.
/ 20
This manual is suitable for:
Brite Striper 2000
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved