Pioneer AVIC-F88DAB Installation Manual

Also see for AVIC-F80DAB: Owner's manual System firmware update instructions Important information for the user Installation manual Operation manual

Contents

Precautions beforeconnecting the systemWARNINGDo not take any steps to tamper with or dis-able the handbrake interlock system whichis in place for your protection. Tamperingwith or disabling the handbrake interlocksystem could result in serious injury ordeath.CAUTION! If you decide to perform the installationyourself, and have special training and ex-perience in the mobile electronics instal-lations, please carefully follow all of thesteps in the installation manual.! Secure all wiring with cable clamps orelectrical tape. Do not allow any bare wir-ing to remain exposed.! Do not directly connect the yellow lead ofthis product to the vehicle battery. If thelead is directly connected to the battery,engine vibration may eventually causethe insulation to fail at the point wherethe wire passes from the passenger com-partment into the engine compartment. Ifthe yellow lead’s insulation tears as a re-sult of contact with metal parts, short-cir-cuiting can occur, resulting inconsiderable danger.! It is extremely dangerous to allow cablesto become wound around the steering col-umn or gearstick. Be sure to install thisproduct, its cables, and wiring away insuch so that they will not obstruct or hin-der driving.! Make sure that the cables and wires willnot interfere with or become caught inany of the vehicle’s moving parts, espe-cially the steering wheel, gearstick, hand-brake, sliding seat tracks, doors, or any ofthe vehicle’s controls.! Do not route wires where they will be ex-posed to high temperatures. If the insula-tion heats up, wires may becomedamaged, resulting in a short circuit ormalfunction and permanent damage tothe product.! Do not cut the GPS aerial cable to shortenit or use an extension to make it longer.Altering the aerial cable could result in ashort circuit or malfunction.! Do not shorten any leads. If you do, theprotection circuit (fuse holder, fuse resis-tor or filter, etc.) may fail to work properly.! Never feed power to other electronic pro-ducts by cutting the insulation of thepower supply lead of this product and tap-ping into the lead. The current capacity ofthe lead will be exceeded, causing over-heating.Before installing this product! Use this product with a 12-volt battery andnegative earthing only. Failure to do so mayresult in a fire or malfunction.! To avoid shorts in the electrical system, besure to disconnect the (–) battery cable be-fore installation.Engb 5EnglishSection02Connection