Patton electronics SMARTNODE 4900 User Manual

Also see for SMARTNODE 4900: Quick start guide Getting started guide

Contents

Patton electronics SMARTNODE 4900 User Manual Manual pdf 38 page image

1. Configure IP address 38SmartNode 4900 User Manual 4 • Getting started with the SmartNode 4900 Series3. Loading the configuration (see figure 16). Refer to section “2. Connecting the SmartNode to the net-work” on page 41 for details.Figure 16. Loading the configurationNote You can manually configure the SmartNode. You do not have to loada configuration file.1. Configure IP addressFactory-default IP settingsBoth Ethernet interfaces are activated upon power-up. The LAN interface ETH 0/1 (LAN) provides a defaultDHCP server. The factory default configuration for the Ethernet interface IP addresses and network masks arelisted in table 9. Both Ethernet interfaces are activated upon power-up. LAN interface ETH 0/1 (LAN) pro-vides a default DHCP server.If these addresses match with those of your network, go to section “2. Connecting the SmartNode to the net-work” on page 41. Otherwise, refer to the following sections to change the addresses and network masks.Table 9. Factory default IP address and network mask configurationIP Address Network MaskWAN interface Ethernet 0 (ETH 0/0) DHCP DHCPLAN interface Ethernet 1 (ETH 0/1) 192.168.1.1 255.255.255.0(/24)DHCP IP address range 192.168.1.10 - 192.168.1.19 255.255.255.0(/24)100-240V(50-60 Hz)1 AMPUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICINGUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICING100-240V(50-60 Hz)1 AMPETH 0/0NIC ADDRESS00:A0:BA:00:04:10ConsoleTelco Ports501ResetExpansionETH 0/1StatusActivity2. Modify the configuration as needed3. Load configuration onto the SmartNode1. Download configuration example from the CD-ROMincluded with your SmartNode device or from thePatton Web server at www.patton.com/voipLAN (ETH 0/1)LANInternet orWAN (optional)WAN(ETH 0/0)