Introduction 37SmartNode 4900 User Manual 4 • Getting started with the SmartNode 4900 SeriesIntroductionThis chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.Setting up a new SmartNode consists of the following main steps:Note If you have not already installed the SmartNode, refer to chapter 3,“Hardware installation” on page 24.1. Configuring the desired IP address (see figure 14). Refer to section “2. Connecting the SmartNode tothe network” on page 41 for details.Figure 14. Connecting the SmartNode to your laptop PC2. Connecting the SmartNode to the network (see figure 15). Refer to section “1. Configure IP address” onpage 38 for details).Figure 15. Connecting the SmartNode to the network100-240V(50-60 Hz)1 AMPUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICINGUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICING100-240V(50-60 Hz)1 AMPETH 0/0NIC ADDRESS00:A0:BA:00:04:10ConsoleTelco Ports501ResetExpansionETH 0/1StatusActivityConsole portLaptop PCModel 16F-561adapter and cable100-240V(50-60 Hz)1 AMPUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICINGUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICING100-240V(50-60 Hz)1 AMPETH 0/0NIC ADDRESS00:A0:BA:00:04:10ConsoleTelco Ports501ResetExpansionETH 0/1StatusActivityLAN (ETH 0/1)NetworkinterfacePC or workstationor TelnetLANInternet orWAN (optional)WAN(ETH 0/0)
