Patton electronics SMARTNODE 4900 User Manual

Also see for SMARTNODE 4900: Quick start guide Getting started guide

Contents

Patton electronics SMARTNODE 4900 User Manual Manual pdf 35 page image

Installing the IpChannel Bank 35SmartNode 4900 User Manual 3 • Hardware installation3. Insert the stripped end of the positive lead into the +DC input of the terminal block. Tighten the screwuntil the power lead is firmly fastened. Repeat the procedure for the negative lead, using the -DC input ofthe terminal block. Make sure that all strands of the wire are captured and that there are no exposed wires.4. Repeat steps 1 through 3 to install the remaining DC power connection.5. Connect the equipment to a 36–72 VDC, 2.5A supply source that is electrically isolated from the ACsource. The 36–72 VDC source is to be reliably connected to earth ground.6. Verify that the green POWER LED is lit.Hardware installation is complete. Refer to chapter 4, “Getting started with the SmartNode 4900 Series” onpage 36.An approved external power supply that incorporates a discon-nect device must be used and positioned within easy reach ofthe operator’s position.CAUTION