Patton electronics RocketLink-G 3088 Series Quick Start Manual

Also see for RocketLink-G 3088 Series: User manual User manual

Contents

Patton electronics RocketLink-G 3088 Series Quick Start Manual Manual pdf 5 page image

Model 3088 Quick Start Guide 5Connect the serial cable to the RocketLink-G serial port as follows:1. Attach the male connector of the serial cable to the female serial connector on the RocketLink-G.2. Attach the other end of the cable to the serial connector on the local serial NTU.Note The V.35 interface is wired as a DCE. To connect the V.35 interface to third-party equipment wired as aDCE, you must use a tail-circuit cable. You can purchase a tail-circuit cable from a datacom-supply ven-dor. A tail-circuit cable will cross-over the necessary V.35 signals so that the two DCE interfacescan communicate.Note You can connect the V.35 interface to an M/34 connector using Patton’s Model 2-34F25Minterface adapter.Note The X.21 interface is wired as a DCE. If you need to change the orientation ti DTE, refer to section “Con-necting the Model 3088/D (X.21) Serial Interface” in the Model 3088 Series Getting Started Guide,The X.21 interface requires a cable with a male DB-15 connector.Note You can configure the T1/E1 interface to either recover the network clock from the T1/E1 line or supplythe network clock for the T1/E1 line.5.0 Additional informationFor detailed information about installing, configuring, operating, and troubleshooting, refer to the Model 3088Series Getting Started Guide on the enclosed Patton CD-ROM or at www.patton.com/manuals.A.0 Compliance InformationA.1 ComplianceEMC:• FCC Part 15, Class A• EN55022, Class A• EN55024• GOST-RSafety:• UL 60950-1/CSA C22.2 N0. 60950-1• IEC/EN60950-1• AS/NZS 60950-1• GOST-RPSTN Regulatory:• FCC Part 68• CS03