Patton electronics RocketLink-G 3088 Series Quick Start Manual

Also see for RocketLink-G 3088 Series: User manual User manual

Contents

Patton electronics RocketLink-G 3088 Series Quick Start Manual Manual pdf 4 page image

4 Model 3088 Quick Start GuideFigure 2. Model 3088/CA front panel2.3 Power up indicationVerify that the Power LED (see figure 2) illuminates and remains lit.3.0 Connect the G.SHDSL port1. Obtain single-twisted-pair cable with an RJ-45 plug connector at each end.2. Plug one end of the cable into the RJ-45 socket (labelled DSL) on the RocketLink-G NTU.— If you are connecting to a DSL service, plug the other end of the cable into the RJ-45 wallsocket that provides your G.SHDSL service.— If connecting to another RocketLink-G, verify the other end of the cable is connected to theDSL port on other RocketLink-G and the DSL port is correctly configured.3. When a DSL link is established, the front-panel DSL LED will turn on.4.0 Connect the serial portYour RocketLink-G comes with one of the following serial WAN ports for connection to an NTU:• V.35 (DB-25F)—Model 3088/CA• X.21 (DB-15)—Model 3088/D• T1/E1 (120-Ohm RJ-48C and dual 75-Ohm BNC connectors)—Model 3088/K• T1/E1 (RJ-48C)—Model 3088/TDSLTerminalConsoleTM / ERRPower