Parkside PTSS 1200 A1 Operation And Safety Notes

Also see for 1200 A1: Operation and safety notes Translation of the original instructions

Contents

Parkside PTSS 1200 A1 Operation And Safety Notes Manual pdf 13 page image

13GB/IEOperation / Maintenance and Cleaning / WarrantyCutting (with guide track) 21Perpendicular cuts with guide track 21Place the guide track 21 with expanded rubberelements onto the work piece.Place the tool with the groove 20 onto the guidetrack 21 .Switch on the device as described under “Swit-ching on and off“.Hold the tool by the handles, 3 and 15 , withboth hands and swivel it.Mitre cuts to 45 °Place the guide track 21 with expanded rubberelements onto the work piece.Place the tool with the groove 20 onto the guidetrack 21 .Set the cutting angle and cut line as specified.Hold the tool by the handles 3 and 15 withboth hands.Switch on the device as described under “Swit-ching on and off“. Start the tool down on thework piece at the front of the saw stand 9 .Move the motor downward and cut, applyingsteady forward pressure, never backwards.Plunge cuts with guide trackPlace the guide track 21 with expanded rubberelements onto the work piece.Place the tool with the groove 20 onto the guidetrack 21 .Set the desired plunge depth as specified above.Place the rear edge (if possible) against a stop(see Fig. D).Switch on the device as described under “Swit-ching on and off“.Hold the tool by the handles, 3 and 15 , withboth hands and swivel it.Note: the cutting width marker 16 on the side of theguard indicates the front and back cutting points ofa 165 mm saw blade at maximum cutting depth. Thisapplies to plunge cuts with fence 21 as well as plungecuts without fence 21 .Any other applications are prohibited.Maintenance and CleaningRISK OF INjURy! Switch thedevice off and pull the plug out of the mains socketbefore carrying out any work on the device.The device must always be kept clean, dry andfree of oil or grease.Use a dry cloth to clean the housing.If the connection cable needs tobe replaced, this repair must be performed by themanufacturer or a representative to prevent safetyhazards.Note: Spare parts not listed (e.g. carbon brushes,switches) can be ordered through our call centre.WarrantyThe warranty for this appliance is for 3years from the date of purchase. The ap-pliance has been manufactured with careand meticulously examined before deliv-ery. Please retain your receipt as proofof purchase. In the event of a warrantyclaim, please make contact by telephonewith our Service Department. Only in thisway can a post-free despatch for yourgoods be assured.The warranty covers only claims for material andmaufacturing defects, but not for transport damage,for wearing parts or for damage to fragile compo-nents, e.g. buttons or batteries. This product is for pri-vate use only and is not intended for commercial use.The warranty is void in the case of abusive and im-proper handling, use of force and internal tamperingnot carried out by our authorized service branch. Yourstatutory rights are not restricted in any way by thiswarranty.The warranty period will not be extended by repairsmade unter warranty. This applies also to replacedand repaired parts. Any damage and defects extanton purchase must be reported immediately after