Parkside PSBS 24 A1 Operation And Safety Notes

Also see for PSBS 24 A1: Operation and safety notes Operation and safety notes Operation and safety notes

Parkside PSBS 24 A1 Operation And Safety Notes Manual pdf 41 page image

41GB/MTPreparing for use Push the coupler (see Fig. A) onto the recharge-able battery pack 9 . Insert the mains pluginto the socket. The red charge indicator LED 15 indicates that thecharging process has started. The red light goes outas soon as the battery pack 9 is fully charged. The green charge indicator LED 16 shows thatthe charging process is complete and thebattery pack 9 is ready for use.NOTE: If the rechargeable battery pack is dischargedand still hot from from the tool being used, it will notbe recharged immediately. The charging processwill start automatically, as soon as the rechargeablebattery pack has cooled to an adequate temperature. Do not use the quick-charge process to chargea battery pack 9 for a second time in closesuccession. Otherwise there is the danger thatthe battery pack 9 will become overchargedand its useful life and that of the charger reduced. Switch the charger 14 off for at least 15 min-utes between successive charging processes.To do this pull the mains plug out of the socket. Inserting / removing the batterypack into / out of the deviceRemoving the rechargeable battery pack: In order to remove the rechargeable battery,turn the appliance 180°. Press the unlocking button 8 and push the re-chargeable battery pack 9 out of the appliance.Inserting the rechargeable battery pack: Push the rechargeable battery pack 9 ontothe appliance. Checking the batterycharge state Press the battery charge state test button 3 .The remaining charge capacity is shown on theLED display 2 . 2-speed gear operationIn first gear (gear selector switch 1 inposition: 1)the device achieves a speed of approx. 500 min -1and a high torque. For example, for screwing workwith small screw diameters.In second gear (gear selector switch 1 inposition: 2)the device achieves a speed of approx. 1800 min -1and a lower torque. For example, for rapid drillprogress in masonry or large drill or screw diameters. Torque preselectionUse the torque preselection ring 13 to set the torque.When this set torque is reached the clutch decouplesthe drive. This allows you to screw in screws to apredetermined depth, which is ideal e.g. for screw-ing in a series of screws. Select a lower setting for small screws or softmaterials. Select a high setting for large screws, hard ma-terials, or when screwing out screws. For drilling tasks select drilling setting by placingthe torque preselection ring in the position. Drilling / screwing /impact drillingDrilling / screwing: Turn the setting ring 12 to the symbol .Impact drilling: Turn the setting ring 12 to the symbol . Changing inserted toolsYour cordless hammer drill has a fully automatic spindlelock and is fitted with a single-sleeve drill chuckwith radial lock “Made in Germany” by .Once the motor has come to a halt, the drive shaftis automatically locked so that the quick-action drill