Installation Instruction – SW3-0914x4 MiMo Directional Panel AntennaIntroductionA.The WMM4G[G]-6-60 is a range of directional panel antennas for 4G/5Gapplications requiring support for 4x4 MiMo with optional GPS/GNSS.Ideal for branch or failover applications the antenna is suitable for external orinternal mounting. The antenna is supplied as standard with a low profi le wallmount bracket and a multi-tilt bracket for wall or mast mounting.SW3-091 - Document Version 1.1Planning the installationB.To minimize the effects of surrounding objects, the antenna should be located as far away from other structures as possible. Iffi tted with GPS/GNSS the antenna should have a clear view of the sky.The antenna is directional with a horizontal beam width of around 90 degrees depending on frequency band, so the selectedSelect a mounting location to ensure that the antenna is facing the direction of the strongest signal, which may not be pointingdirectly towards the network base station. The orientation of the antenna should be vertical with the cable exiting downwards.A low profi le wall mount bracket is supplied allowing flat fitment to a wall with no adjustment. Alternatively, if the antenna is fi tted toa panel with rear access, then it can be secured to the panel using suitable length M6x1 machine screws into the threaded bushesin the antenna back plate.A multi-tilt bracket is also supplied for mounting to a mast (diameter <60mm [2.36”] ) or wall – this allowsadjustable vertical and horizontal tilt.Safety NotesC.• The antenna is designed to be mounted by a professional installer. Please seek professional advice from an accreditedinstaller regarding the installation if in any doubt.• If the antenna will be fi tted to an existing mast, please ensure that it will not overload it.• Ensure that the installation location can be safely accessed with the equipment that you have available.• If mounting to a wall in a possition which is accessible care should be taken to ensure that no one comes within 1m (3’) ofthe antenna during use.CAUTIONParts of the antenna are an electrical conductor. Contact with power lines can result in death, or seriousinjury. Do not install the antenna where there is any possibility of contact with (or high voltage arc-over from)power cables. The antenna and supporting mast must not be close to any power lines during installation,removal or in the event that part of the system should accidentally fall.CAUTIONIf the antenna is installed above the roof line or in an exposed location, it is advisable to fi t lightning surgearrestors in the coaxial cable feed line.Suitable units should be sourced and installed as per the manufacturer instructions.The installer is responsible for determining if this is a requirement for the antenna installation.Electrical Safety NoteVariants of this product contain an active GPS/GNSS antenna. Rated voltage: 3-5VDC Rated current: 20mA maxi-mum. The supply to this device must be provided with overcurrent protection of 1A maximum.