Panorama Antennas WMM4G-6-60 Installation Instruction

Panorama Antennas WMM4G-6-60 Installation Instruction Manual pdf 2 page image

Mounting Using the Low Profile Wall BracketD.Offer the antenna to the mounting bracket face, fi t the supplied bolts with washers and tighten securely. Do not over-tighten as itmay warp the back plate.Ensure there are no obstructions or utilities behind the mounting surface. Use the bracket as a template to mark the mounting holepositions. Select the correct size drill bit to suit the wall plug, drill holes and insert wall plugs. Align the bracket over the preparedholes, insert screws and fully tighten evenly. Drill any hole/s required for cable routing as appropriate.Safety Check: Ensure that the bracket is securely fi xed to wall before fi tting the antenna.Offer the antenna and bracket to the wall mounting tilting the antenna slightly away from the wall and sliding the two prongs onthe antenna bracket into the locations on the wall bracket until the antenna locates. Be careful not to trap or damage the cable.Pole Mounting using the Adjustable BracketE.Fit bracket to antenna using supplied screws, washers and nuts. Offer the multi-tilt bracket to mast in selected position and fi t Vbolts with washer & nuts. Tighten by hand to allow fi nal positioning and alignment of the bracket. Note: minor directional adjust-ment in both azimuth (horizontal)[+/- 40deg] and elevation (vertical) [+/-20deg]can be made using the tilt/swivel feature. Oncecorrectly aligned, fully tighten the V bolts evenly from each side to secure the bracket.Caution: Do not overtighten the V bolts as this may damage or distort the mast tube section.

/ 4

Related manuals for Panorama Antennas WMM4G-6-60