Panasonic viera th-l32x20a Operating Instructions Manual

Also see for TH-L32X20A: Operating instructions

Panasonic viera th-l32x20a Operating Instructions Manual Manual pdf 31 page image

Advanced Tuning and Editing ChannelsChannel List Skip unwanted channels / Edit channels (Change name, Move)Auto Tuning Set all Analogue TV channels automaticallySelect a channel and reveal / hideAnalogue TV Channel List1234567BBC1******************************:reveal:hide (skip)To reveal all channels● YChannel positionChannel nameTo edit channelsYou can also edit each channel in Channel List.Select a channel to edit and:If a VCR is connected only with the RF cable, edit “VCR”.●Manual Tuning Set Analogue TV channel manuallyYou can hide unwantedchannels. The hiddenchannels cannot bedisplayed except in thisfunction.Use this function to skipunwanted channels.reveal / hideselectAutomatically retune allAnalogue TV channelsreceived in the area.Settings are made automaticallyStart Auto TuningSet Analogue TV channel manually after AutoTuning.If a VCR is connected only with the RF● cable, select channel position “0”.All analogue TV tuning data will be erasedAnalogue TV Auto TuningEXITRETURNStart Auto TuningAnalogue TV Auto TuningemaNlennahCRF ChAnalogue TV: 0SearchingThis will take about 3 minutes.Scan CH0 75All the previous tuning settings are erased.● When the operation is completed, the channel at channel position “1” will be displayed.● Search begins in the order from the lower channels to the higher channels. Channels received● during this process are added to the list (see above).If tuning has not been done completely● “Manual Tuning” (see below)0CH33Analogue TV Manual TuningManual Tuning 0 75CH1Select a channel position Select a channel Search and storestoresearch1 BBCCH 02 Prompt StreetAll Analogue Channels21:35 pmorAnalogue TV Tuning MenuTo rename the channel name● BUser inputNameA B C D E F G H I J K L M NU V W X Y Z 0 1 2 3 4 5 6a b c d e f g h i j k l m nu v w x y z ( ) + - . * _O P Q R S T7 8 9 ! : #o p q r s t(maximum: five characters)setselectStoreRETURNSet characters● You can set characters by using numericbuttons (p. 22).31StoreGTo move the channel position● GSelect the new position