Panasonic lh1760 Operating Instructions Manual

Panasonic lh1760 Operating Instructions Manual Manual pdf 8 page image

8POWER switchSwitches the power supply ON/OFF. When the power is ON, the LED (green) lights up.INPUT SELECT buttonsSelects the signal input line. The green LED light above the button indicates the selected input signal.VIDEO : Video inputY/C : Y/C inputSDI1 : Serial digital interface input (HD/SD compatible)SDI2 : Serial digital interface input (HD/SD compatible)YPBP R/RGB : Analog component (YP BP R) or RGB input. Also compatible with PC input RGB.* When using PC Input, select “RGB-COMP.” from “YP BP R/RGB” in the “INPUT SELECT”menu (J page 22).DVI-D : DVI-D input (HDCP compatible)* When using PC Input, select “DVI-COMP.” from “DVI-D” in the “INPUT SELECT” menu(J page 22).* The monitor retains the input signal settings selected when the monitor was last switched ON or OFF.MENU, FUNCTION buttonsUse these buttons to display menus, select and adjust settings and confirm menu selections.MENU : Press to open a menu, exit a menu or return to a previous menu./FUNCTION1 : Moves the cursor downwards and selects items.It also confirms a menu item assigned to FUNCTION1./FUNCTION2 : Moves the cursor upwards and selects items.It also confirms a menu item assigned to FUNCTION2.ENTER/FUNCTION3 : Press to confirm a setting or to open a submenu.It also confirms a menu item assigned to FUNCTION3.* When the control lock is on, the key mark appears and FUNCTION does not operate.FUNCTION4 : Confirms a menu item assigned to FUNCTION4.FUNCTION5 : Confirms a menu item assigned to FUNCTION5.Picture adjusting knobPHASE 0 – 60 (30)CHROMA 0 – 60 (30)BRIGHT 0 – 60 (30)CONT[CONTRAST] 0 – 60 (50) / B.LIGHT [BACKLIGHT] 0 – 60 (50)( ) denotes factory preset values.A rotating knob that can be pushed to operate. You can display and adjust the menu settings by pushing theknob. The setting values are saved by pushing the knob again.When values are changed from the factory preset values, the LED above the knob (amber) lights.The setting values are loaded when the monitor’s power is switched ON. The setting values are saved whenthe knob is pushed, or when 10 seconds pass after changing the settings. However, operating changescannot be made in the following cases.* When the control lock is on, the key mark appears and setting values cannot be changed (J page 23).* When the MONO function is ON (J page 17), [PHASE] and [CHROMA] operations are disabled.* When using “RGB-COMP.” input, [PHASE] and [CHROMA] operations are disabled.* While operating HV DELAY (J page 18) (when set to any other setting than OFF), [BRIGHT] operation is disabled.Volume knobYou can adjust the speaker and headphones volume by rotating the volume knob.SpeakerAudio input from the AUDIO input terminal or SDI terminal (embedded audio) can be heard.Connecting headphones to the HEAD PHONE output connector turns off the speakers.Front panelControls and Their Functions (continued)