Note• The password lock function supports only SDHC memory cards and SDXC memory cards.When a card that does not support password lock is inserted in either SD memory card 1 or SD memorycard 2, this function is unavailable.• If you will use the SD memory card on a device other than the camera with password lock configured,remove the password using the password lock remove button before removing the SD memory card.The password cannot be removed on devices (such as PCs) other than the camera.• When the “Status” of “SD memory card password lock” is “Lock”, if an SD memory card with noconfigured password is inserted, the password is automatically configured to the SD memory card.IMPORTANT• If you forget the configured password, the password cannot be removed. The SD memory card withthe configured password will become unusable, so manage passwords with great care.• If you forget the configured password and you want to replace the SD memory card with a new one,perform 1 of the following steps to set the “Status” of “SD memory card password lock” to “Unlock”before replacing the SD memory card.– Use the password lock remove button to enter a password and then press the [Set] button. In thiscase, even if you enter an incorrect password, the “Status” will change to “Unlock”.– Initialize settings from the “Maintenance” page (®page 201).Operating mode[Recording mode]Set the recording mode to save data on the SD memory card.• Single recording: Recorded data is saved to either SD memory card 1 or SD memory card 2. Select thissetting when you want to save recorded data for long periods of time.• Dual recording: The same recorded data is saved to both SD memory card 1 and SD memory card 2.This enables data to be saved even if one of the SD memory cards becomes damaged. Select this settingif you want high reliability when saving data. If only one SD memory card (SD memory card 1 or SD memorycard 2) is set to “Use”, images will only be saved on the SD memory card set to “Use”.Default: Single recordingNote• Even if dual recording is selected, data will not be saved if both SD memory card 1 and 2 are damaged.• When using dual recording, if the capacity of the SD memory cards connected to SD memory 1 andSD memory card 2 are different, data will be saved up to the upper limit of the SD memory card withsmaller capacity.• When the setting of “Recording mode” is changed between “Single recording” and “Dual recording”,format the SD memory card.[Audio recording]Select whether or not to save audio data when saving video data in MP4 format.• Off: Does not save audio data to videos (MP4 format).• On: Saves audio data (AAC-LC format) to videos (MP4 format).Default: Off[Remaining capacity notification]When the E-mail notification function or the Panasonic alarm protocol function is used to provide notificationof the remaining capacity of the SD memory card, select a level to be notified at from the following.50%/ 20%/ 10%/ 5%/ 2%• Default: 50%56 Operating Instructions10 Configure the basic settings of the camera [Basic]
