Note• Notification will be provided each time the remaining capacity of the SD memory card reached thevalues above.For example, notification will be provided each time the remaining capacity reaches 50%, 20%, 10%,5% and 2% when “50%” is selected. Notification may not always be made at the very moment whenthe remaining capacity of the SD memory card has reached each value.• When “Use” is selected for SD memory 1 and SD memory 2 and “Single recording” is selected for“Recording mode”, the combined remain capacity of both SD memory 1 and SD memory 2 will benotified.• When “Use” is selected for SD memory 1 and SD memory 2 and “Dual recording” is selected for“Recording mode”, the remaining capacity of the SD memory card with the smaller capacity will benotified.[Overwrite]Determine whether or not to overwrite when the remaining capacity of the SD memory card becomesinsufficient.• On: Overwrites when the remaining capacity of the SD memory card becomes insufficient. (The oldestimage is the first to be overwritten.)• Off: Stops saving images on the SD memory card when the SD memory card becomes full.• Default: OffRecording stream 1/Recording stream 2[Recording format]Select the type of image data to be recorded on the SD memory card.“Off” can only be selected for the “Recording format” of “Recording stream 2”.“JPEG(1)”, “JPEG(2)”, and “JPEG(3)” can only be selected for the “Recording format” of “Recording stream1”.• Off: Does not record data.• JPEG(1): Records still image data (JPEG(1)). The data is recorded in accordance with the settings of“JPEG(1)” on the [JPEG/H.264] tab of the “Image/Audio” page.• JPEG(2): Records still image data (JPEG(2)). The data is recorded in accordance with the settings of“JPEG(2)” on the [JPEG/H.264] tab of the “Image/Audio” page.• JPEG(3): Records still image data (JPEG(3)). The data is recorded in accordance with the settings of“JPEG(3)” on the [JPEG/H.264] tab of the “Image/Audio” page.• H.264(1): Records video data (H.264(1)) in the MP4 video encoding format. The data is recorded inaccordance with the settings of “H.264(1)” on the [JPEG/H.264] tab of the “Image/Audio” page.• H.264(2): Records video data (H.264(2)) in the MP4 video encoding format. The data is recorded inaccordance with the settings of “H.264(2)” on the [JPEG/H.264] tab of the “Image/Audio” page.• H.264(3): Records video data (H.264(3)) in the MP4 video encoding format. The data is recorded inaccordance with the settings of “H.264(3)” on the [JPEG/H.264] tab of the “Image/Audio” page.• H.264(4): Records video data (H.264(4)) in the MP4 video encoding format. The data is recorded inaccordance with the settings of “H.264(4)” on the [JPEG/H.264] tab of the “Image/Audio” page.• Default:– Recording stream 1: JPEG(2)– Recording stream 2: OffIMPORTANT• If an SD memory card with an SD Speed Class other than 10 is used, 2048x1536 cannot be selectedfor the image capture size of JPEG images. If “Dual recording” is selected for “Recording mode”, the“Image saving interval” of JPEG images may be limited to “0.5fps” or lower. Set the maximum combinedOperating Instructions 5710 Configure the basic settings of the camera [Basic]
