Note• Some cellular phones cannot change the image capture size even when resolution is changed byresolution control.• Depending on the image capture size selected for “JPEG(1)”, “JPEG(2)”, or “JPEG(3)”, “Resolution”may not be able to be used.• When the HTTP port number is changed from “80”, enter “http://IP address: (colon) + port number/mobile”*1 in the address box of the browser. When using the DDNS function, access to “http://Hostname registered in the DDNS server: (colon) + port number/mobile”.• When “HTTPS” is selected for “HTTPS” - “Connection” on the [Advanced] tab of the “Network” page,enter as follows.“https://IP address: (colon) + port number/mobile” or “https://Host name registered in the DDNS server:(colon) + port number/mobile”• When the authentication window is displayed, enter the user name of an administrator or user andpassword. Depending on the cellular phone in use, password entry may be required each time thescreen is switched.• It is impossible to transmit/receive audio using a cellular phone.• Depending on the cellular phone in use, larger size images may not be displayed. In this case, selecting“9 Low” for “Image quality setting” of “JPEG” (®page 77) may sometimes solve this problem.• Depending on the cellular phone in use or its contract plan, it may be impossible to access.*1 IP address is the global WAN IP address of the router that can be accessed via the Internet.*2 When “User auth.” is set to “On” (®page 134), only users with the access level of “1. Administrator” or “2. Camera control” will bedisplayed.2.2 Monitor images on a mobile terminalIt is possible to connect to the camera using a mobile terminal via the Internet and monitor images (MJPEGonly) from the camera on the screen of the mobile terminal. It is also possible to refresh images to display thelatest image.The compatible mobile terminals are shown as follows. (As of October, 2013)– iPad, iPhone, iPod touch (iOS 4.2.1 or later)– Android™ mobile terminalsWhen an Android terminal is used, an MJPEG format image is displayed by the Firefox® browser, but a JPEGformat image is displayed by the standard browser.For further information about compatible devices, refer to our website(http://security.panasonic.com/pss/security/support/info.html).IMPORTANT• When the authentication window is displayed, enter the user name and password. The default username and password are as follows.User name: adminPassword: 12345To enhance the security, change the password for the user “admin”. (®page 134)Note• It is necessary to configure the network settings of the mobile terminal in advance to connect to theInternet and monitor images from the camera. (®page 139)Operating Instructions 192 Monitor images on a cellular phone/mobile terminal
