Pin No. Designation-1-Video Output BoardWV-PB5504AEBefore attempting to connect or operate this product, please read these instructions completelyPREFACEThe WV-PB5504AE Video Output Board is provided for expanding the video output capability of theMatrix Switcher.APPEARANCE1. Alarm Output/Reset Output Connector (ALARM OUT/RESET OUT)External Timing Input Connector (EXT TIMING IN)Recover Input Connector (RECOVER IN)ALARM OUT: When the Matrix Switcher receives an alarm from the WV-PB5564E Alarm Boardor camera site receivers WV-RC100, WV-RC150 or WV-RC170, the alarm output signal isprovided at this connector for the Time Lapse VTR. The active pin number of the alarm out-put depends on the alarm mode set by the on-screen programme (Mode-1, Mode-2,Mode-3).RESET OUT: When the Matrix Switcher resets the activated alarm, the alarm reset output sig-nal, either Open Collector or pulse, is provided at this connector for the Time Lapse VTR.EXT TIMING IN: The camera switching interval (Sequential Dwell Time) can be synchronizedwith the lapse mode set in the Time Lapse VTR.EXT. TIMING IN 1 controls Monitor 1 output, EXT. TIMING IN 2 controls Monitor 2 output, etc.Supply the camera switching pulse from the Time Lapse VTR to this connector. Minimumduration for camera switching pulse needs to be more than one (1) second.RECOVER IN: This connector accepts the alarm recover signal from the Time Lapse VTR.When handling this board, hold only by circuit board edges. Otherwise components on theboard may be damaged by static electricity.Caution12345678910111213141516171819202122232425ALARM OUT 1RESET OUT 1RECOVER IN 1GroundEXT TIMING IN 1GroundALARM OUT 2RESET OUT 2RECOVER IN 2GroundEXT TIMING IN 2(+5V DC)ALARM OUT 3RESET OUT 3RECOVER IN 3GroundEXT TIMING IN 3GroundALARM OUT 4RESET OUT 4RECOVER IN 4GroundEXT TIMING IN 4GroundGroundOUTINOUTINOUTINOUTINMONITORALARM OUTRESET OUTEXT TIMING INRECOVER INOUTPUT1234qw25 132423222120191817161514121110987654321