Panasonic WV-LC1700 Operating Instructions Manual

Panasonic WV-LC1700 Operating Instructions Manual Manual pdf 18 page image

18Setting item4. Move the cursor to the following setting items by pressing the C or D button. Then, adjust the levels by pressing the + or –button.Effect Setting valueH-POSITIONV-POSITIONCLOCKPHASE+: Screen moves upwards.–: Screen moves downwards.+: Clock is enlarged.–: Clock is contracted.+: Phase is increased.–: Phase is decreased.–20 to +20–20 to +200 to +63+: Screen moves to the right.–: Screen moves to the left.–40 to +40 Setting of PC InputWhile the PC input signal is being selected, you can adjustthe horizontal position and vertical position.Note: Since this unit detects input signals and makes auto-matic adjustments as required, this setting is notrequired in ordinary cases.1. Press the MENU button. The top menu will be displayed.2. Move the cursor to PC SETUP by pressing the C or Dbutton. Press the MENU button. The PC SETUP menuwill be displayed.Present input signals are displayed in the menu title.For PC input terminal: PC INV I D E O A D J U S TP C S E T U PL A N G U A G EE X I TAccording to the timing data table ( page 9), presentsignals are displayed at the right side of the menu title inthe format of [Resolution@Refresh rate (Vertical frequen-cy)].3. Move the cursor to AUTO by pressing the C or D but-ton. Press the MENU button. The image display positionwill be adjusted automatically.Note:• The screen flickers during automatic adjustments. Thisis, however, not a malfunction.• According to the situation of video signals, it takes sev-eral seconds to 10-odd seconds to complete automaticadjustments.If an optimal screen cannot be obtained after automaticadjustments, further operation specified below may beneeded.H-POSITIONV-POSITIONCLOCKPHASEAUTOEXIT0000+01+38PC IN 1280 x 1024@60 Hz5. Select EXIT, and press the MENU button. The top menu will be displayed.6. Select EXIT on the top menu, and press the MENU button. The monitor display return to the default status.Note:• If no operation has been performed for 10 seconds or more, the monitor display returns to the default status.• Check if the VGA output setting has been performed for the connected PC. (Refer to p. 9.)• This monitor does not support plug-and-play. Depending on the connected PC, the PC SETUP menu can be controlled fromthe PC keyboard. However, proper adjustment is not supported.