Panasonic WV-CW384E Operating Instructions Manual

Also see for Super Dynamic III WV-CW380: Brochure & specs Brochure & specs

Contents

Panasonic WV-CW384E Operating Instructions Manual Manual pdf 22 page image

22 Basic operationThe following are descriptions of how to configure each setup item using the operation buttons (refer to page 8) on the cam-era. Setup using an optional system controller is also available.Note:• The illustrations below are the examples to be displayed on a video monitor.1. Hold down the [SET] button for around 2 seconds.→ The top page will be displayed.2. Move the cursor onto "END" by press the [UP] or [DOWN] but-ton.MODEL WV-CW380 SERIESCAMERAOBACK-FOCUSOSPECIALOLANGUAGEOEND SETUP DISABLE3. Press the [SET] button after moving the cursor onto "SETUP" bypressing the [RIGHT] button.→ The "DISABLE" indication will change into "ENABLE" andthe settings will become editable.MODEL WV-CW380 SERIESCAMERAOBACK-FOCUSOSPECIALOLANGUAGEOEND SETUP ENABLE4. Move the cursor onto the desired setup item and press the[SET] button.→ The setup page of the selected setup item will be dis-played.5. Configure the settings for each item.Select setup item: Move the cursor by pressing the [UP] or[DOWN] button.Change the parameter: Press the [LEFT] or [RIGHT] button.Display the detailed settings page of the setup item: Pressthe [SET] button when the setup item with the [O] mark isselected.Go back to the previous page: Move the cursor onto "RET"and press the [SET] button.Go back to the top page: Move the cursor onto "TOP" andpress the [SET] button.**CAMERA SETUP** 1/2CAMERA ID OFFOALC ALCOSHUTTER OFFAGC ON(HIGH)SENS UP OFFSYNC INTWHITE BAL ATW1OMOTION DET MODE1ODNR HIGHRESOLUTION HIGHBW MODEO**CAMERA SETUP** 2/2PRIVACY ZONE OFFEL-ZOOM OFFSTABILIZER OFFLED ONRET TOP END6. To exit from the SETUP menu and display images from the camera, move the cursor onto "END" and press the [SET] but-ton.Notes:• To prevent erroneous operations, the "DISABLE" indication will always be displayed when the top page is displayed fromthe camera. To operate the SETUP menu, switch the "DISABLE" indication to the "ENABLE" indication first.• The cursor position will be displayed highlighted.