Panasonic WJ-NX400K Important Information Manual

Also see for WJ-NX400K: Operating instructions Installation guide Installation guide Important information Operating instructions

Panasonic WJ-NX400K Important Information Manual Manual pdf 18 page image

18Rear view① Alarm/Control connector [ALARM/CONTROL]This connector is used when connecting with an externaldevice such as a sensor or anti-theft door switch that out-put alarm signals, or when connecting an alarm devicesuch as a buzzer or a lamp to the external equipment.The two provided terminal plug (12 pin) can be mounted.② Alarm In connector [ALARM IN]It is used when connecting with an external device such asa sensor or anti-theft door switch that output alarm signals.The two provided terminal block plugs (16) can be mounted.③ Security wire holeMount the lock device for the anti-theft security wire.④ Cable clamp fixing hole (for fixing terminal blockcable)This is a fitting hole for the (provided) clam to tie and fix theterminal block cables. Refer to ☞ page 19 for fitting.⑤ Copy port (USB3.0) [COPY]Connect an external storage device (external Hard diskdrive, USB memory) to this port and copy images andaudio recorded on the hard disk drive. An externalstorage device can also be connected to the copy porton the front. Use either of them.* Mouse connection is also available.⑥ Mouse connection port (USB2.0) [MOUSE]The provided mouse is connected to this port. Themouse can be connected to the mouse connectionports on the front. Use either of them.⑦ Network port (PC port) [PC]Connect the recorder with a PC via a network compati-ble with 10BASE-T, 100BASE-TX or 1000BASE-T. Usethis port when the cameras and the PC are connectedto different network.⑧ Network port (Camera/PC port) [CAMERA/PC]Connect the recorder with a PC and cameras via anetwork compatible with 10BASE-T, 100BASE-TX or1000BASE-T. When the port is being accessed, theaccess indicator (green) blinks. When the port is beinglinked, the link indicator (orange) lights.Camera/PCAccess indicator Link indicatorPCLAN (10/100/1000 BASE-T)⑨ Audio output connector (RCA pin jack)[AUDIO OUT]Connect such device as a powered speaker. Sameaudio output to the main monitor will be output from thisconnector.⑩ Video output connector (BNC) [VIDEO OUT]Connect a sub monitor (BNC) to this connector. Sameimages output from the sub monitor output connector(HDMI) will be output from this connector.The default is NTSC output. The setup menu will not bedisplayed.⑪ Main monitor output connector (HDMI)[A/V OUT MAIN]This connector is used to connect to an HDMI-readymonitor (the main monitor). It displays live images,recorded images, or the setup menu of the recorder.⑫ Sub monitor output connecter (HDMI)[VIDEO OUT SUB]This connector is used to connect to an HDMI-readymonitor (sub monitor). Only the live images will be dis-played.➀⑧ ⑨ ⑩ ⑪ ⑫ ⑬➁➄⑥⑰➂➃⑭⑦ ⑮ ⑯Major operating controls and their functions (continued)