60Technical InformationAuto AspectThe optimum size and aspect can be chosen automatically, and you can enjoy finer images. (p. 16)Aspect Control Signal■“WIDE” will appear in the top left of the screen if a Widescreen signal (WSS) or a Control signal through SCART /HDMI terminal is found.The aspect will switch to the appropriate 16:9 or 14:9 widescreen ratio.This function will work in any aspect mode.Input terminal Input signal formatAspect Control SignalWidescreen signal(WSS)Control signalthrough SCART (pin8) / HDMI terminalCableRFDVB-CDVB-TPAL B, G, H, IPAL D, KSECAM B, GSECAM L, L’SECAM D, KPAL 525/60 6.5 MHz –PAL 525/60 6.0 MHz –PAL 525/60 5.5 MHz –M.NTSC 6.5 MHz –M.NTSC 6.0 MHz –M.NTSC 5.5 MHz –AV1 (Composite)AV2 (Composite or S-Video)AV3PALSECAMPAL 525/60 –M.NTSC –NTSC –COMPONENT525 (480) / 60i –525 (480) / 60p –625 (576) / 50i625 (576) / 50p750 (720) / 60p –750 (720) / 50p –1,125 (1,080) / 60i –1,125 (1,080) / 50i –HDMI1HDMI2525 (480) / 60i –525 (480) / 60p –625 (576) / 50i –625 (576) / 50p –750 (720) / 60p –750 (720) / 50p –1,125 (1,080) / 60i –1,125 (1,080) / 50i –1,125 (1,080) / 60p –1,125 (1,080) / 50p –1,125 (1,080) / 24p –Auto mode■Auto mode determines the best aspect ratio to fill the screen. It does this using a four step process (WSS,Control signal through SCART / HDMI terminal, Letterbox detection, or Justify to fill the screen) to determine.This process may take several minutes, depending on the darkness of the image.Letterbox detection: If black bands at the top and bottom of the screen are detected, Auto mode chooses thebest ratio and expands the image to fill the screen.If no aspect signals are detected, Auto mode enhances the image for optimum viewing pleasure.NoteThe ratio varies depending on the programme, etc. If the ratio is out of the standard 16:9, black bands at the top●and bottom of the screen may appear.If the screen size looks unusual when a widescreen-recorded programme is played back on a VCR, adjust the●tracking of the VCR. Read the manual of the VCR.