Panasonic Viera TX-P42S30E Operating Instructions Manual

Also see for TX-P42S30J: Service manual

Contents

Panasonic Viera TX-P42S30E Operating Instructions Manual Manual pdf 15 page image

Auto SetupQuick Start Guide145 1 [DVB-C Network Settings]• Depending on the country you select, select your cable provider beforehand by following the on screen instructions.Frequency AutoNetwork IDStart Auto SetupAutoDVB-C Network Settingsaccessselect[Start Auto Setup]abc defjklghi mnotuvpqrs wxyzNormally set [Frequency] and [Network ID] to [Auto].If [Auto] is not displayed or if necessary, enter [Frequency] and [Network ID] specified by your cable provider withnumeric buttons.2 [DVB-C Auto Setup] 3 [DVB-T Auto Setup]0% 100%123100100CBBC ChannelBBC Radio WalesE4100SearchingDVB-C Auto SetupProgressThis will take about 3 minutes.No. Channel Name TypeFree TVFree TVFree TVQualityFree TV: 3 Pay TV: 0 Radio: 0CH 5 69626262100100CBBC ChannelBBC Radio WalesE410062 100Cartoon NwkSearchingCH Channel Name TypeFree TVFree TVFree TVFree TVQualityFree TV: 4 Pay TV: 0 Radio: 0DVB-T Auto SetupProgressThis will take about 3 minutes.• Depending on the country you select, the channel selection screen willbe displayed after DVB-T Auto Setup if multiple channels have the samelogical channel number. Select your preferred channel or exit the screenfor automatic selections.4 [Analogue Auto Setup] 5 Preset DownloadCH 29CH 33 BBC1CH 2 78 41CC 1SearchingCH Channel NameAnalogue: 2Analogue Auto SetupScanThis will take about 3 minutes.If Q-Link, VIERA Link or similar technology (p. 72, 73) compatiblerecorder is connected, channel, language, country / region settings areautomatically downloaded to the recorder.0% 100%Sending Preset DataPlease wait!Remote control unavailable• If downloading has failed, you can download later through the SetupMenu. [Download] (p. 35)6 Setup the network connectionSetup the network connection to enable the network service functions such as VIERA Connect, etc. (p. 17, 63).• To setup the wireless connection, the Wireless LAN Adaptor (optional accessory) is required.Please note that this TV does not support wireless public access points.• Ensure the network connections (p. 12) and network environment are completed before starting setup.Select the network typeNetwork SetupSelect Wired or WirelessWired Wireless Set later[Wired] “Wired connection” (p. 12)[Wireless] “Wireless connection” (p. 12)accessselect • To setup later on or skip this stepSelect [Set later] or EXIT■ [Wired]1. Select [Auto]Check network cable connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection.Connection Test : succeededThe test is successfuland the TV is connectedto the network.: failedCheck the settings andconnections. And thenselect [Retry].Acquire IP AddressAuto ManualaccessselectAutomatically setup is done and the test of the networkconnection starts.• To set manually, select [Manual] and set each item. Fordetails (p. 65)2. Go to the next step 7(Press twice)