Panasonic Viera TX-P42S20L Operating Instructions Manual

Also see for Viera TX-P42S20L: Service manual Service manual

Panasonic Viera TX-P42S20L Operating Instructions Manual Manual pdf 65 page image

Frequently Asked Questions● FAQs, etc.65Problem ActionsScreenChaotic image, noisy Set “P-NR” in the Picture Menu (to remove noise). (p. 26)●Check nearby electrical products●(car, motorcycle, fluorescent lamp).No image can be displayed Is “Contrast”, “Brightness” or “Colour” in the Picture Menu set to the●minimum? (p. 26)Blurry or distorted image(no sound or low volume) Reset channels. (p. 32 and p. 33)●Unusual image is displayed Turn the TV Off with Mains power On / Off switch, then turn it On●again.If the problem persists, perform “Shipping Condition” (p. 44).●SoundNo sound is produced Is “Sound mute” active? (p. 8)●Is the volume set to the minimum?●Sound level is low orsound is distortedSound signal reception may be deteriorated.●Set “MPX” (p. 27) in the Sound Menu to “Mono”. (Analogue only)●HDMISound is unusualSet the sound setting of the connected equipment to “2ch L.PCM”.●Check the “HDMI1 / 2 / 3 Input” setting in the Sound Menu. (p. 27)●If digital sound connection has a problem, select analogue sound●connection. (p. 63)Pictures from externalequipment are unusualwhen the equipment isconnected via HDMICheck the HDMI cable is connected properly. (p. 58)●Turn the TV and equipment Off, then turn them On again.●Check an input signal from the equipment. (p. 63)●Use an equipment compliant with EIA/CEA-861/861B.●OtherThe TV does not switch On Check the mains lead is plugged into the socket outlet.●The TV goes into Standby mode Auto power standby function is activated. (p. 8)●The TV enters Standby mode about 30 mins. after analogue●broadcasting ends.The remote control does not workor is intermittentAre the batteries installed correctly? (p. 6)●Has the TV been switched On?●The batteries may be running low. Replace them.●Point the remote control directly at the front of the TV (within about●7 m and a 30 degree angle of the front of the TV).Situate the TV away from sunshine or other sources of bright light●not to shine on the TV’s remote control signal receiver.Parts of the TV become hot Even when the temperature of parts of the front, top and rear●panels has risen, these temperature rises will not pose anyproblems in terms of performance or quality.Permanently lit spots on screen Due to production process involved in this technology this may●result in some pixels which are permanently lit or unlit. This is not amalfunction.An error message appears Follow the message’s instructions.●If the problem persists, contact your local Panasonic dealer or the●authorized Service Centre.

/ 68

Related manuals for Panasonic Viera TX-P42S20L