DIRECT TV RECASPECT NINPUTTV AVOPTIONTEXT STTL INDEX HOLDPROGRAMMERETURNTVjklghi mnotuvpqrs wxyzabc def12Auto SetupSearch and store TV channels automatically.These steps are not necessary if the setup has been completed by your local dealer.●Please complete connections (p. 10 and p. 11) and settings (if necessary) of the connected equipment before●starting Auto Setup. For details of settings for the connected equipment, read the manual of the equipment.1 Plug the TV into mains socket and switch On(Takes a few seconds to be displayed)2 Select the languageOSD LanguageDeutsch Dansk Polski SrpskiEnglish Svenska čeština HrvatskiFrançais Norsk Magyar SlovenščinaItaliano Suomi Slovenčina LatviešuEspañol Türkçe Български eesti keelPortuguêsNederlandsЕλληνικά Românǎ Lietuviųselectset3 Select your countryCountryGermany Denmark PolandAustria Sweden CzechFrance Norway HungaryItaly Finland SlovakiaSpain Luxembourg SloveniaPortugalSwitzerlandMaltaAndorraBelgium EstoniaNetherlands LithuaniaTurkeyGreeceIrelandOthersselectsetDepending on the country you select, you●may be required to select the Region. Inthis case, select your region.4 Select the mode you want to tuneDADHDTV Signal SelectionDVB-CDVB-TAnalogueStart Auto SetupDVB-T support for HD servicesselecttune / skip tuning: tune (the mode will be tuned andsearched for the available channels): skip tuning“DVB-C” may not appear depending on the●country you select (p. 67).5 Select “Start Auto Setup”DADHDTV Signal SelectionDVB-CDVB-TAnalogueStart Auto SetupDVB-T support for HD servicesselectaccessAuto Setup starts Auto Setup will start to search for TV●channels and store them.The stored channels and sorted channelorder vary depending on the country, area,broadcasting system and conditions ofsignal reception.If tuning has failed, check the connection●of the RF cable, and then, follow the onscreen instructions.