Using Network Services (DLNA / VIERA Connect)765 Select [Connection Test] and access to testab-cd-ef-gh-ij-klConnection Test AccessNetwork TypeAccess Point SettingsIP/DNS SettingsNetwork Link SettingsSoftware UpdateMAC AddressNetwork SetupWirelessConnected accessselectPerforms automatic testing of the network connection for the TV. (It takes a whileto test.)Check access point connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection.Connection Test : succeededThe test is successful and the TV is connected to the network.: failedCheck the settings and connections, and then perform this function again.If you continue to have difficulty, please contact your internet service provider.■ [WPS(Push button)]1) Please press the ‘WPS’ button on the accesspoint until its light flashes.2) When the light is flashing select ‘Connect’ onTV.If you are unsure, please check the instructionmanual of the access point.WPS(Push button)Connectpress the WPS button on the access point until the light flashesconnect the Wireless LAN Adaptor and the access point• Ensure that your access point supports WPS for this setup.• WPS : Wi-Fi Protected Setup™■ [WPS(PIN)]1 Select your desired access point123Access Point ASSIDAccess Point BAccess Point C11n(2.4GHz)11n(5GHz)11n(5GHz)Available Access PointsNo. Wireless type Encrypt Receptionaccessselect• Ensure that your access point supports WPS for this setup.• To search access points again(yellow)• For the information of the highlighted access point • To set manually(red)2 Enter the PIN code to the access point, and then select [Connect]Please register the following PIN codes on theaccess point.PIN code : 12345678Select ‘Connect’ after entering and saving thesettings on the access point.WPS(PIN)Connect■ [Search for access point]Access points found automatically are listed.1 Select your desired access point123Access Point ASSIDAccess Point BAccess Point C11n(2.4GHz)11n(5GHz)11n(5GHz)Available Access PointsNo. Wireless type Encrypt Receptionaccessselect: Encrypted access point• To search access points again(yellow)• For the information of the highlightedaccess point • To set manually(red)