Timer Programming | Child Lock47■ To change a timer programming eventSelect the programme to be changedaccessselectCorrect as necessary (p. 46)■ To cancel a timer programming eventSelect the programme to be deleted(red)■ To record with subtitles (if available)Select the programme to record with subtitles(yellow)• Each time pressed :auto off■ To cancel a timer programming eventtemporarilySelect the programme to be cancelled(blue)• Each time pressed :cancel stop cancellingNote• Check that the LED is orange. If not, timer programmes are not active or not stored.• Timer Programming reminder messages will remain displayed until one of the following occurs :• You press the OK button to view the programme or the EXIT button to cancel the reminder.• The timer programming event that the reminder is set for ends.• “!” identifies that any timer programming events have overlapped. [Ext Rec.] and [USB HDD Rec.] are given priority over[Reminder]. As for the overlapped two or more [Ext Rec.] / [USB HDD Rec.], the first timer programming event starts andfinishes as programmed. The next timer programming event can then start.• The recording of Timer Programming will automatically change to the programmed channel 10 seconds before the starttime.• To stop recording the timer programming event directly prior to the start time, it may be necessary to stop the recordermanually.• The recording of Timer Programming will be performed even if the TV is in REW LIVE TV recording (p. 58) or Pause Live TVrecording (p. 87). In this case, these recordings will be cancelled.Child LockYou can lock specific channels / AV input terminals and control who watches them.When the locked channel / input is selected, a message appears; by entering the PIN number, you can watch it.1 Display the menuMENU2 Select [Setup]Main MenuPictureSoundTimerSetupaccessselect3 Select [Child Lock] 1/2AccessEco NavigationRecording SetupLink SettingsChild LockDVB-C Tuning MenuLanguageDisplay SettingsCommon InterfaceNetwork Setupaccessselect■ To return to TVEXIT