Panasonic Viera TX-P42G30E Operating Instructions Manual

Also see for TX-P42G30E: Operating instructions Service manual

Contents

Panasonic Viera TX-P42G30E Operating Instructions Manual Manual pdf 42 page image

Tuning and Editing Channels (DVB)42Set DVB channel manually [Manual Tuning]Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.If tuning has not been done completely or for adjusting the direction of the aerial, use this function.• All channels found will be added to the Channel List.DVB-C :1 Enter the frequency 2 Select [Start scan]74,00 MHz4100 %100 %DVB-C Manual TuningFrequencyAutoSymbol RateService ID AutoStoppedStart scanSignal QualitySignal StrengthNo. Channel Name Type NewFree TV: 0 Pay TV: 0 Radio: 0abc defjklghi mnotuvpqrs wxyz• Normally set [Symbol Rate] and[Service ID] to [Auto].accessselectDVB-T :1 Adjust frequency for each channel 2 Search100[CH21] 474,00 MHz%100 %StoppedDVB-T Manual TuningFrequencySignal QualitySignal StrengthNo. Channel Name Type NewFree TV: 0 Pay TV: 0 Radio: 0 Data: 0adjust frequencyselect channel• Set where the level of [Signal Quality]becomes the maximum.Update DVB channel automatically [Update Channel List]You can add new channels, delete removed channels, update channel name and position automatically to Channel List.CH 5 69SearchingDVB-T Update Channel ListProgressThis will take about 3 minutes.CH Channel Name Type QualityFree TV: 0 Pay TV: 0 Radio: 0• Channel List is updated while keeping your settings in [Favourites Edit],[Channel List], [Child Lock], etc.• Depending on the signal condition, the update may not work properly.Display a notification message [New Channel Message]Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]New channels found!Press OK to update channel list.Press EXIT to ignore.• Selecting OK will perform [Update Channel List].Check DVB signal [Signal Condition]Selects a channel and checks the DVB signal condition.A good Signal Strength is not an indication of suitable signal for DVB reception.Please use the Signal Quality indicator as follows :[Signal Quality] :• Green bar Good• Yellow bar Poor• Red bar Bad (Check the Terrestrial aerial or cable)• To change the channelExample :70 CBBC Channel9080%%0.00E+00Wenvoe802,00 MHz, 64 QAM, 6940 kS/sDVB-C Signal ConditionSignal QualityChannel NameSignal StrengthBit Error RateNetwork NameParameterThese bars show the maximum signal value of the selected channel.Reduce the DVB-C signal [Attenuator]If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.• This function is available only for DVB-C signal.