Panasonic Viera TX-L26X10B Operating Instructions Manual

Also see for TX-L42S10B: Brochure & specs

Panasonic Viera TX-L26X10B Operating Instructions Manual Manual pdf 67 page image

On screen messagesFrequently Asked Questions FAQs, etc.67OtherThe TV does not switch OnPress and hold the standby On / Off switch on the remote control for about 1 second if Power LED is red.Check the mains lead is plugged into the socket outlet. The fuse in the mains plug may have blown. Replace it with one of an identical rating (p. 4).The TV goes into “Standby mode” Off Timer function is activated. The TV enters “Standby mode” about 30 mins. after analogue broadcasting ends.The remote control does notwork or is intermittentAre the batteries installed correctly? (p. 6) Has the TV been switched On? The batteries may be running low. Replace them. Point the remote control directly at the front of the TV (within a 30 degree angle of the front of the TV).Situate the TV away from sunshine or other sources of bright light not to shine on the TV’s remote control signal receiver.There may be red spots, bluespots, green spots and blackspots on the screenThis is a characteristic of liquid crystal panels and is not a problem. The liquid crystal panel is built with very high precision technologygiving you fine picture details.Occasionally, a few non-active pixels may appear on the screen asa fixed point of red, green, blue or black.Please note this does not affect the performance of your LCD.The LCD panel moves slightlywhen it is pushed with a fingerClattered sound might be heardThere is some flexibility around the panel to prevent damage to the panel.The panel might move slightly when it is pushed with a finger, and clattered sound might be heard. This is not a malfunction.An error message appears Follow the message’s instructions. If the problem persists, contact the authorized Service Centre.Message Meaning / ActionAll tuning data will be erased “Shipping Condition” will erase all tuning data (p. 41).Are you sure ? Confirm correct operation.Are you sure you want to delete this timer ?Press OK to delete timerPress RETURN to returnConfirm correct operation.Bad signalThe signal is weak. Check the aerial is plugged in properly. It may be necessary to have an aerial installer check the signal and aerialalignment.Reset channels. (p. 34 and p. 35)Child Lock is active !Press OK to enter PIN.The selected channel is locked in Child Lock (p. 40). You must enter the PIN number before the channel will be displayed.Feature not availableIt is not possible to record from COMPONENT, HDMI or PC. Connect the recorder to the TV using a fully wired SCART cable for recording from theTV tuner.Confirm Q-Link and VIERA Link settings (p. 50 - p. 53)On screen messagesProblem Actions