Panasonic Viera TX-26LXD65F Operating Instructions Manual

Contents

Panasonic Viera TX-26LXD65F Operating Instructions Manual Manual pdf 25 page image

AdvancedIDTVEXITMENUOKMain menuPicture menuSound menuSetup menuChild LockProfile EditTuner LockDVB Setup MenuSystem UpdateTeletextSubtitlesTuning MenuOffgergerMulti Audio gerAccessSystem SetupMENU25• Common interface module (DVB)• Editing and Setting Channels (DVB)Common Interface ModuleThe Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.These can be inserted in the “CI” slot located at the rear of the TV.IMPORTANT NOTES:• This TV receiver works only Pay TV modules complying with CI standard.• Switch off the TV using the control panel switch before inserting or removing a module.• If you are installing a TV software update, please follow the dedicated instructions suppliedwith the module.• Insert / remove a module straightly to the CI slot.Insert the CI module:Some Common Interface Modules may be a two piece design consisting of acard reader together with the viewing card. When using this design of card,first insert the card reader firmly into the CI slot on the TV.Secondly, insert the viewing card into the reader.If no module is inserted the message “No module inserted” will be displayed. (If you have inserted a module, checkthat it is fully inserted.)The features that now appear on screen are dependent on the contents of the selected Common Interface Module.Refer to the instructions supplied with the card or contact the vendor.In all cases, it is possible to navigate the pages using buttons on the remote control, but because the commandsavailable must apply to all manufacturers of DVB equipment, some on screen commands may not correspondexactly to the remote control buttons.For example:For the on screen command ‘select’ or ‘go’, use the OK button. OKSwitch on the TV.Auto3 secondsCommon Interface ModuleTime ZoneDVB System Setup AccessDisplay TimeoutPreferred Language SettingSlot 1: No module insertedCommon Interface Module Access312Display the menuSelect "Setup menu"Select"DVB Setup Menu"nextselectnextselectSelect "System Setup"4 nextselect5 setselectŶTo exitEXITSelect the “Common Interface Module” and set(DVB mode)