Panasonic Viera TX-26LXD60A Operating Instructions Manual

Panasonic Viera TX-26LXD60A Operating Instructions Manual Manual pdf 45 page image

FAQs, etc.45Problem Actions• Frequently Asked QuestionsScreen HDMISound DVB• Due to the digital reception technologies involved, quality of the DTV signals may be relatively low insome cases, despite good reception of analogue programmes.OtherChaotic image, noisy • Set "P-NR" in the Picture menu (to remove noise). (p. 21)• Check nearby electrical products (car, motorcycle, fluorescent lamp).No image can be displayed • Is "Colour" or "Contrast" in the Picture menu set to theminimum? (p. 21)Blurry or distorted image(no sound or low volume) • Reset channels. (p. 28 and p. 30)No sound is produced • Is "Sound Mute" active? (p. 7)• Is the volume set to the minimum?Sound level is lowor sound is distorted • Sound signal reception may be deteriorated.• Set "NICAM" (p. 20) in the Sound menu to "Off".(Analogue only)Interference orfrozen / disappearingimage in DVB• Check "Signal Condition". (p. 28)If "Signal Quality" or "Signal Strength" are displayed inred, check aerial.If problem persists, consult your local Panasonic dealer.• Use the remote control to turn Off the TV unit, then turnit On again.Sound is unusual • Set the sound setting of the connected equipment to "2ch L.PCM".• Check the "HDMI1 input" setting in the Sound menu. (p. 21)• If digital sound connection has a problem, selectanalogue sound connection. (p. 21)Pictures from externalequipment are unusualwhen the equipment isconnected via HDMI• Is the HDMI cable connected properly? (p. 40)• Turn Off the TV unit and equipment, then turn them Onagain.• Check an input signal from the equipment. (p. 43)• Use an equipment compliant with EIA/CEA-861/861B.TV unit goes into"Standby mode"• The sleep function is activated.• The TV unit enters "Standby mode" about 30 min.after broadcasting ends.The remote controldoes not work • Are the batteries installed correctly? (p. 6)• Has the TV unit been switched On?"Control with HDMI"function does not work • Switch the TV unit on again with the equipment on.• Set "Control with HDMI" to "Off", then set to "On" again. (p. 38)• Install an aerial individually for the TV unit and VCR(or use a splitter).TVVCR(Individual aerial)(Individual aerial)AerialInputterminalSplitterAerial OutputAerial InputAerial OutputUnable to receive signalswith a high-performanceaerial

/ 48

Related manuals for Panasonic Viera TX-26LXD60A