Panasonic Viera TX-26LXD60A Operating Instructions Manual

Panasonic Viera TX-26LXD60A Operating Instructions Manual Manual pdf 4 page image

4Safety PrecautionsAC 220-240 V50 HzWarnings & PrecautionsIMPORTANT: THE MOULDED MAINS PLUGFOR YOUR SAFETY, PLEASE READ THE FOLLOWING TEXT CAREFULLY.The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the mains plug which ismarked with the letter E or by the Earth symbol or coloured GREEN or GREEN-AND-YELLOW.The wire which is coloured BLUE must be connected to the terminal in the mains plugwhich is marked with the letter N or coloured BLACK.The wire which is coloured BROWN must be connected to the terminal in the mains plugwhich is marked with the letter L or coloured RED.How to replace the fuse.Open the fuse compartment with a screwdriver and replace the fuse.As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markingsidentifying the terminals in your mains plug, proceed as follows.WARNING: – THIS APPARATUS MUST BE EARTHED.IMPORTANT: – The wires in this mains lead are coloured in accordance with the following code: –Green-and-Yellow: Earth Blue: Neutral Brown: LiveIf a new mains plug is to be fitted, please observe the wiring code as shown below.If in any doubt, please consult a qualified electrician.If the fitted moulded mains plug is unsuitable for the socket outlet in your home, then the fuse shall beremoved and the mains plug cut off and disposed of safety. There is a danger of severe electrical shockif the cut off mains plug is inserted into any 13 amp socket.If the mains plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced.If you lose the fuse cover the mains plug must not be used until a replacement cover is obtained.A replacement fuse cover may be purchased from your local Panasonic Dealer.This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse isfitted in this mains plug. Shall the fuse need to be replaced, please ensure that the replacement fuse has a ratingof 5 amps and that it is approved by ASTA or BSI to BS1362.Check for the ASTA mark ASA or the BSI mark on the body of the fuse.Handling the mains plugEnsure that the mains plug is easily accessible at alltimes. The On/Off switch on this model does not fullydisconnect the TV from the mains supply. Remove themains plug from the wall socket when the TV set isnot used for a prolonged period of time. Remove themains plug from the wall socket before connecting ordisconnecting any leads.NoteIf the set is not switched off when the TV station stopstransmitting, it will automatically go to standby mode after 30minutes. This function will operate only in Analogue TV model.Do not expose todirect sunlight andother sources of heatAvoid exposing the TV set to directsunlight and other sources of heat. Toprevent fire never place any type ofcandle or naked flame on top or nearthe TV set.Power sourceThis TV set is designed to operate on 220-240V,50 Hz AC.