12Connecting the Display Unit and the Tuner BoxPlease ensure that the display unit and the tuner box are disconnected from the mains sockets before attaching ordisconnecting any leads.Wired connectionIf you are going to place the tuner box close to the display unit, it is recommended to connect them using supplied HDMI cable.BARear of the Display UnitRear of the Tuner BoxAC 220 - 240 V50 / 60 Hz MainsleadTuner Box HDMI cable3.0 mWireless connectionYou can place the tuner box and the display unit in a flexible way using the wireless unit (not using any cablesbetween the display unit and the tuner box). If you choose to use the wireless connection between the displayunit and the tuner box, ensure that the wireless transmitter and the wireless receiver are positioned to faceeach other without any obstructions.The wireless unit uses 60 (59.40 - 61.56) GHz frequency band. Do not use the wireless unit near the equipmentusing the same frequency band to avoid the interference.It may take a while to change the input mode when using the wireless unit. To resolve this, use supplied HDMIcable to connect the display unit and the tuner box.Picture and sound may be interrupted or the TV may not be operated properly depending on the setting placeof the wireless transmitter or obstacles (furniture, AV equipment, rack, rack door, etc.) between the wirelesstransmitter and the wireless receiver. To resolve this, change the installation layout without any obstacles betweenthe wireless transmitter and the wireless receiver.●●●Transmission range of the Wireless Unit : Available area to place the wireless transmitter40°5°WirelessTransmitterWirelessTransmitterView from the sideView from the top10 m10 m5 m5 m80° 80°WirelessReceiverDisplay UnitTuner BoxTuner BoxWirelessReceiver45°45°5 m5 mAdjust the angle of thewireless transmitter to facethe wireless receiver.●DisplayUnitCautionDo not place the wireless unit in the following locations to avoid poor signal condition or TV failures.Location subject to be high temperature (near the heater, etc.)Location with poor air circulation (at the end of a closed rack, etc.)Keep the wireless unit away from the devices such as wireless LAN, microwaves, mobile phones or otherelectric equipment to avoid radio wave interference. Otherwise malfunction or slow response may occur.● ••●NoteThe range may be shortened depending on the obstacles, the surrounding environment or building structure.Ensure the wireless transmitter is facing the wireless receiver.●●If the display unit is connected to external equipment other than the supplied tuner box by using HDMI cable, thefollowing icon will be displayed on the screen.Some functions may not be available depending on the connected equipment.●●Basic Connection