Panasonic Viera TH-P50VT20Z Operating Instructions Manual

Panasonic Viera TH-P50VT20Z Operating Instructions Manual Manual pdf 7 page image

6Accessories / OptionsDo not disassemble or modify the pedestal.Otherwise the TV may fall over and become damaged, and personal injury may result.●Do not use the pedestal for any other TV or displays.Otherwise the TV or the display may fall over and become damaged, and personal injury may result.●Do not use the pedestal if it becomes warped or physically damaged.If you use the pedestal while it is physically damaged, personal injury may result. Contact your● nearest Panasonic dealer immediately.During set-up, make sure that all screws are securely tightened.If insufficient care is taken to ensure screws are properly tightened during assembly, the pedestal● will not be strong enough to support the TV, and it might fall over and become damaged, andpersonal injury may result.Ensure that the TV does not fall over.If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over● and personal injury may result.Two or more people are required to install and remove the TV.If two or more people are not present, the TV may be dropped, and personal injury may result.●When removing the pedestal from the TV, do not remove the pedestal by any methods otherthan the specified procedure. (see below)● Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.Attaching / removing the pedestalAssembly screw (3)(silver)Assembly screw (4)(black)Pole BaseM5 × 18 M5 × 30Assembling the pedestalUse the assembly screws to fasten the poleto the base securely.Make sure that the screws are securely● tightened.Forcing the assembly screws the wrong way● will strip the threads.Securing the TVInsert the pole into the TV, and then fastensecurely with the assembly screws .Make sure that the screws are securely● tightened.Carry out the work on a horizontal and level● surface.Removing the pedestal from the TVBe sure to remove the pedestal in the following way when using the wall hanging bracket or repackingthe TV.Remove four assembly screws from the TV.Pull out the pedestal from the TV.Remove three assembly screws from the pole.DAFrontDB[View from the bottom]Hole for pedestalinstallationArrow mark