Panasonic Viera TH-L42U30S Operating Instructions Manual

Panasonic Viera TH-L42U30S Operating Instructions Manual Manual pdf 34 page image

Tuning and Editing Channels34AYtS■YS•••1••••S1[Auto Tuning] - Set all Digital TV channels automatically1 Start Auto Tuning 2 Settings are made automaticallyDigital TV Auto TuningAll digital TV tuning data will be erasedCH 5SearchingCH Channel Name Type QualityDigital TV: 4 Radio: 0Digital TV Auto TuningScanDigital TVTV Finland32 1This will take about 3 minutes.69Digital TVTV Finland32 1Digital TVSVT HD32 1Automatically retuneall Digital TV channelsreceived in the area.• All the previous tuning settings are erased.• When the operation is completed, the channel at channel position [1] will be displayed.• Search begins in the order from the lower channels to the higher channels.• If tuning has not been done completely [Manual Tuning] (see below)[Manual Tuning] - Set Digital TV channel manuallyNormally use [Auto Tuning] or [Update Channel List] to update Digital TV channels on your channellist. If tuning has not been done completely or for adjusting the direction of the aerial, use this function.[CH21]1010StoppedNo. Channel Name Type NewDigital TV: 0 Radio: 000Digital TV Manual TuningFrequencySignal QualitySignal Strength474,00 MHzselect frequencystart scanselect offset• All channels found will be added to the Digital TV Channel List.[Update Channel List] - Update channels automaticallyYou can add new channels, delete duplicated channels, update channel name and positionautomatically to Channel List.69CH 5SearchingCH Channel Name Type QualityDigital TV Update Channel ListScanDigital TV: 0 Radio: 0This will take about 3 minutes.• Channel List is updated while keeping your settings in[Favourites Edit], [Channel List], [Child Lock], etc.• Depending on the signal condition, the update may not workproperly.[New Channel Message] - Display a notification messageSelects whether to give a notification message when a new Digital TV channel is found. [Off] / [On]New channels found!Press OK to update channel list.Press EXIT to ignore.• Selecting OK will perform [Update Channel List].[Signal Condition] - Check Digital TV signalSelects a channel and checks the Digital TV signal condition.• To change the channel CHChannel NameSignal QualitySignal StrengthNetwork NameParameter101 DZFinfokanalRiksTV0 2 4 6 8 10[CH32] 562.00 MHzDigital TV Signal ConditionThese bars show the maximum signal value of theselected channel.A good Signal Strength is not an indication of suitable signal forDigital TV reception. Please use the Signal Quality indicator asfollows:[Signal Quality]:• Green bar Good• Yellow bar Poor• Red bar Bad (Check the aerial)