8AccessoriesRequires two AA batteries.1. Turn the transmitter face down.Press and slide off the batterycover.2. Install the batteries as shown in thebattery compartment.(Polarity + or – must match themarkings in the compartment.)Precaution on battery useIncorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.Disposal of batteries should be in an environment-friendly manner.Observe the following precautions:1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.2. Do not combine a used battery with a new one.3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.5. Battery replacement is necessary when the remote control acts sporadically or stops operating the LCD Display.3. Replace the cover and slide inreverse until the lock snaps.DISPLAYINPUTSURROUNDVOLN RPICTURE SOUND SET UPASPECTPICTUREPOS. /SIZEOFF TIMERPCMULTIPIP SWAP SELECTZOOMMOVEAccessories SuppliedCheck that you have the Accessories and items shownOperatingInstruction bookRemote ControlTransmitterEUR646535WarrantyAC cordFixing bands × 2Batteries for theRemote ControlTransmitter(AA Battery × 2)Ferrite core(Small size) × 2Ferrite core(Large size) × 2Remote Control BatteriesTwo “AA” sizeHelpful Hint:For frequent remote control users, replace old batteries withAlkaline batteries for longer life.